Reviews
Fits: YAMAHA XJ400 ZS, YAMAHA XJR400, YAMAHA XJR400 R, YAMAHA XJ400 ZE, YAMAHA XJ400 Z, YAMAHA SZR660, YAMAHA SRX600, YAMAHA SRX400, YAMAHA RZ350R(29K), YAMAHA RZ250 RR (29L), YAMAHA RZ250 R (29L), YAMAHA FZR400RSP(87), YAMAHA FZ400 R, YAMAHA FZ400 N, YAMAHA FZ400 K
It could not be installed as is.
I ride an NSR250R-SE (MC28 model) and I like the acceleration so I set the Sprocket to Short.
It is a city & touring car, but it has 13T Front and 48T Rear.
When I looked at the compatibility chart for this product, I found a lineup for a MC28 NSR with a 50T rear sprocket, so I ordered it immediately.
The Bolt hole was a bit gapped, so I had to shave the hole a little bit to avoid eccentricity and managed to install it, but I was somewhat worried because I had machined it myself and ended up returning it.
I hope Manufacturer will also make sure that the car models are compatible with the product.
View detail
Mirror side 10mm
Buy 8mm Adapter, note that it is 8?→Mirror side 10?→Mirror side 8?→Mirror side 10?→Mirror side 8?→Mirror side 10?→Mirror side 10?
I am disappointed because I intended to use the 8mm height adjustment screw. I guess it is only in stock and not produced, but I think a better description of the product is needed.
View detail
Incorrect vehicle type
I purchased this product as a compliant product and will review it as a compliant product
Package was also opened and lubricated and I have no intention of returning it
The vehicle models listed on the product page are [SEROW225 Year:95-] It was
The Product Package you received includes [SEROW225 95-96] It was stated that
In fact, the shape of the push rod side seems to be the same as the 4JG2~4 models
My car is a 97 4JG5 so the OEMParts are different in shape
I tried to see if it was possible to use it even if the shape was different, but the gold part that covers the Clutch Wire was It interfered with Carburetor
Even if you angle the Carburetor to avoid it, the Wire will still make direct contact with the Engine
It is necessary to cut or bend the gold coating on the push rod side I'm sure there is, but I don't feel like doing that kind of processing to Clutch Wire because it's too dangerous Mm
I removed each part for installation, but it was a waste of time
Probably, if it is a 95-96 model year vehicle of the SEROW225, I think it is possible to install it It's just for reference
View detail
Fits: SUZUKI Sky Wave 650, SUZUKI glass tracker, SUZUKI Glass Tracker Big Boy, SUZUKI Glass Tracker Big Boy Fl, SUZUKI Glass Tracker Fl, SUZUKI Wolf 125, SUZUKI SV650, SUZUKI SV650 S, SUZUKI ST250, SUZUKI ST250(Fl vehicle), SUZUKI ST250 E, SUZUKI RG500 "., SUZUKI RG400 "., SUZUKI RG125 "., SUZUKI RA125, SUZUKI GSX400L, SUZUKI GSX400E Katana, SUZUKI GSX1300R Hayabusa, SUZUKI GSX1100S Katana, SUZUKI GS750 GL
Does not fit TU250 grasstracker
Too large to fit the TU250 grasstracker engine. It does not fit inside the "seat" in the engine which the exhaust manifold fits into. I did not try on other bikes. View detail