Reviews
Puch SIDEDownForceSpoiler
In conclusion, it is absolutely impossible to install it properly.
If the pattern paper is Quantity:I also had trouble with only 1pc.
And the pattern paper is not Exactly to match the top?
The location will change by about 5 cm depending on whether you want to adjust it to the bottom or the front or the back
The procedure is different if you refer to the Webike Product Page video for installation
In the video, Plate is applied first, and after 24 hours, Rubber rubber is placed over it.
Product was sent already installed!
This is because the Plate is located behind the Rubber Rubber.
Rubber rubber like Toilet's SUPPON will rebound like Spring and interfere with installation.
I looked it up on the Net and found that those with strong final strength have weak initial strength.
We are a GarageHouse, so our cars and motorcycles are both heated and cooled in the house!
Compress and paste for 1 minute at room temperature above 28 degrees Celsius or
I tried and tried, but it was impossible.
Emon sold separately (amon) Ultra Strong Double-Sided Tape (for Bumper, Spoiler, etc.)
Buy Strong Fixing Type White 25mm×width 2m×length 1.14mm×thickness 1.14mm 3910 for outside of car and
I machined and installed it.
The product is quite straight and is to be mounted on a curved cowl.
It's not so much that it's attached as it is that it's forced to be attached with Strong Double-sided Tape!
The shape does not fit the side cowl of the ZX-10RR at all.
I'm inclined to say that it's a 2021ZX-10R/ZX-10RR exclusive part.
ZX-10RR looks straight but Cowl is quite curved
It doesn't fit at all, especially the Right Side is almost floating.
If this is what you're talking about installing, I'm pretty sure it applies to all other Manufacturer's Motorcycle's.
Whether it is YZF-R1M or CBR1000RR-R, it is possible to paste it!
At the moment, I've driven about 50km to try it out and it hasn't been removed.
It looks cool, so that's good.
View detail