Reviews
Fits: BMW R1200R, BMW R1200GS, BMW R1200GS, BMW R1200GS Adventure, BMW R1200GS Adventure, BMW R1200ST, BMW F650GS, BMW R1200S, BMW R1200GS Adventure, BMW R1200R, BMW R1200GS, BMW K1200R Sport, BMW K1200S, BMW F800ST, BMW K1200R, BMW F800S, BMW F800GS
Screw attached does not work
Although the production of the whole product is reasonable, but the accessory part M5Screw does not work.
Under the neck 35mm incomplete Because it is All Screw, as you go along, the end of the Screw part will bottom at the end of the opponent's Screw,
A gap of about 5 mm is formed between the Bolt seat surface and the Holder and can not be tightened up. Why should I set All Screw?
For the time being, Bolt used NORMAL, Holder fixed properly, Lever fixed point was fixed in 2 → 1 place and started using for the time being. I can use it once, but I can see a little wobble.
(I just attempted to purchase it separately with Screw alone, but I did not see the All Screw setting, so I'm preparing to use M5 Screen with Tap to increase it and use it. )
Although there is no problem in other places, I think that ordinary people are angry Level because there are incompleteness in installation.
View detail
It's pretty nice.
When it is Gloves for winter, when I drive for a long time at High Solo, I got tired very much, but when I used it at a bad Moto, it is very easy to use, it gets tired and it is easy to wear it off. View detail
Fits: BMW R1250RT, BMW R1250GS, BMW R1250GS Adventure, BMW R1200GS LC Liquid Cooling, BMW R1200GS LC Liquid Cooling, BMW R1200GS LC Adventure water-cooled
I think that it is a good product without Wound.
I got on R1200 GS Adventure 2016 but my height was 170 cm, my arms stretched out, I felt that my arm and body did not go with my handlebar's break angle, but I got Handlebar Up kit attached 27 mm Back, 38 mm Up to Handlebar It became very easy to transfer.
As Handlebar got high, the worried Brake hose felt a little pulled Brake hose when Handlebar was cut all the way to Left, Clutch hose is not as much as Brake hose, but it feels a little pulled. However, I do not cut the Handlebar to the full while driving, so I think Large is durable.
What is disappointing is that there are no choices for imported goods, there are a lot of rubbing scratches that stand out on items.
View detail
It is too thick!
Maybe it depends on the type of car, but the geta was too expensive for our vehicles.
It is indeed the primary objective of this Items "It is not buried in Left Side" Has been achieved, but if you mount and stand on Asphalt or Concrete, the Motorcycle stays upright as it falls to Right even if the wind blows.
I was disgusted by searching for earth and grass on the road and stopping it..
View detail
Fits: BMW R1200R, BMW R1200R, BMW F800R, BMW F700GS, BMW F700GS, BMW F800GS, BMW F800R, BMW F800GS, BMW R1200GS Adventure, BMW R1200GS Adventure, BMW R1200GS, BMW HP2-MegaMoto, BMW R1200GS, BMW F800GS Adventure
It can not be attached to F 800 GSA as it is
This product fixes the Clamp attached to Handlebar with Bolt and the other holds this product between MirrorStem, but it can not be done for F800GSA.
The fixed part of the OEM hand guard is attached to the location of the MirrorStem and interferes with this product.
Therefore, when installing with F 800 GSA, you must remove Hand guard.
I cut off the MirrorStem part and fixed it with Tie Wrap.
Wonderlich authorized distributor P & A and webike dealing with that product do not write such things, but please be careful as it is described properly in Wonder Lich's home country Homepage.
I also want agents dealing with this product to properly write a note.
View detail
Wonderlich : Wunderlich Front cowl "Da
Easy to install, you can do it without problems if you do while looking at Instruction Manual. Cowl's making is also solid, Fit feeling is good. Impression of RnineT changes as Large changes if installed Right easy for Custom. View detail
Fits: BMW R1250RT, BMW R1250GS, BMW R1250GS Adventure, BMW R1200GS LC Liquid Cooling, BMW R1200GS LC Liquid Cooling, BMW R1200GS LC Adventure water-cooled
Position is Large thing!
Position is a Large pattern or I'm not comfortable with it since I started riding ~ I have never had any trouble with Position so much - - - The arms are elongated, arm is against the cutting angle of Handlebar, it is hard to get on with the body going on without going.
Wanderlich Handlebar Up kit seems to be able to transfer Handlebar to 27 mm Back, 38 mm Up.
Wonder Rich has released a number of for BMW products and has also purchased experience, product accuracy and quality will not be a problem!
As Handlebar got high, I was concerned about the Harness, Brake hose relationship, but I was instructed to remove Tie Wrap and fix it as Frame in the manual. Clutch side was not particularly problematic.
View detail
Fits: BMW R1200CL, BMW R1200C Montauk, BMW R1200C, BMW K1200RS, BMW K1200GT
Whether it is a material of PP, because it can not be glued, it will be expensive if it breaks.
Although making goods is very good, at the time of installation, one place hooks the claws in the back of BlinkerHousing and fix the other side with the Screw screw, but the clearance with the light bulb Housing is bad, only a little I tried to insert it while pushing it, the claw broke easily.
1 pc in addition. I have no choice but to order it, I think if it is a Material that has elasticity only a little more even with the claw portion. (R1150GS-Adventure 2002MODEL)
In case it is difficult to enter bulb Housing, we recommend you to work with considerable care.
View detail
Fits: BMW F650GS (08-), BMW F700GS (-16), BMW F800R (-11), BMW F800S, BMW F800R (12-14), BMW F650GS (08-), BMW F700GS (-16), BMW F800R (-11), BMW F800S, BMW F800R (12-14)
I do not run the forest road, but I think that it is necessary also on the ordinary road.
Every time the bicycle parking space is unpaved and everyday Motorcycle comes out, the stones are muddy. Even if you are running on an ordinary road after the rain, mud is still there, and a stone splash is normal. In such conditions, since mud is definitely among the fins of the water cooler, it has always been removed using Small Brush. About 80% of mud bounced by attaching this product prevents entry into Water cooler fins.
Installation seems easy, so it's quite Large strange. Shroud It is easy if you take it off, but if you try to attach it without removing it, you must put your hands from the narrow Duct of SIDE and you have to feel yourself screwed.
View detail
Fits: BMW F800R, BMW G650GS, BMW G650GS, BMW R1200GS, BMW F650GS, BMW F800R, BMW R1200GS Adventure, BMW F800R, BMW F800S, BMW F800ST, BMW F650GS Dakar
Parenthesis Well, and low power consumption!
Installation is easy and it looks pretty good.
It is a part that is also friendly to Battery as the power consumption becomes smaller.
I think the price is reasonable as it is an overseas product.
A Wiring diagram of a foreign language is attached, but there is a mistake.
The correct answer is
Tail light side Yellow color to the car body side Black / Gray (Small light) To
Red Red as Green / Red (Stop lamp) Connect to. (In case of G650 GS)
Conversely, License Plate Light shines like Tail light.
Please note that the color of Wiring seems to change with the type of Motorcycle..
View detail
Fits: BMW R1250RT, BMW R1250GS, BMW R1250GS Adventure, BMW R1200GS LC Liquid Cooling, BMW R1200GS LC Liquid Cooling, BMW R1200GS LC Adventure water-cooled
Wonderlich
People who know it is Manufacturer, most products are shaving off, so I think that there is no problem with strength. Depending on the product, but before moving on a bit, Position changes quite a bit, Recommendation can not be made to people with a low height. View detail
In the lower road Helmet's Shield is durable even if it is raised Large
It is as the title. The area is more than twice as large as NORMAL. Until now, when I got over 60 km / h, my breath became breathless and I took down the Shield, but after switching to this Screen I can beat more than 80 km. I will lower the shield on the highway. Touring destination scenery is now better visible.
View detail
A little expensive but this is the place of Camping etc etc. But peace of mind
This Motorcycle gradient is large Lamp Camping place etc etc. , I bought it because it was uneasy to stop at a place where it was not paved.
In fact, I wanted something a little more thick and wanted to get a substitute and slope is eliminated but there is no setting of Lowdown car - - -
Although the price is a bit high, building is also solid and it is possible to stop with confidence.
View detail
Fits: BMW R1250RT, BMW R1250RT, BMW R1200RT LC water-cooled
I felt a sense of stability when I stopped..
Installation Instruction Manual also instructed us to use "Screw lock", but since we did not have any hands, we installed it for the time being. When I noticed the installation Screw was dropped by 1 pc.
I bought Screw lock agent and Stainless Steel dish, Screw at Homsen and reinstalled it. Engine is easy to loosen because there is vibration in BoxerTWIN.
Out on the upper side of the photo is the self-made extended Bracket. The position of STAND is in front of Cylinder, so I tried to attach it because it is hard to get on with my feet.
Since the area became wider, it is stable, but I wonder if I need to pay attention to the pull and pull on the road surface.
View detail
I thought that it would be best for S1000R.
For S1000R Light and MeterPanel (Or the gap with Cowl Bracket) I thought that Screen of the shape that can be filled is the most Parenthesis good husband. I think it is very Parenthesis that the shape has become a rather complicated curved surface. I think that it is the best design including OEM among the S1000R.
Although OEM may be the best windproof performance... I toured about 250 km, but Wind Cutting sounds and vibrating etc etc. There was no negative element of. This is Smoke, but Smoke may be a bit more tight.
View detail
It attaches as a description, and although it does not loosen or separate since the screw-thread lock was also applied firmly, when it parks in a Side stands, tight ? play has a slot on the Side stands end. Since a STAND does not necessarily separate
It attaches as a description, and although it does not loosen or separate since the screw-thread lock was also applied firmly, when it parks in a Side stands, tight ? play has a slot on the Side stands end.
Since a STAND does not necessarily separate even if it sways a Handle somewhat forcibly, the function is carried out.They are full marks if exactly made from the size.
View detail
Although the fixing position puffed the Axel vainly bad, the degree of a fixing position is known immediately and it gets used immediately usage's start. When the Touring of the high-speed lump of about 400 km of round trips was carried out before usi
Although the fixing position puffed the Axel vainly bad, the degree of a fixing position is known immediately and it gets used immediately usage's start.
When the Touring of the high-speed lump of about 400 km of round trips was carried out before using it, the right hand became painful, but when [ of 400 km of
one way ] it was mostly used for migration on a highway, a hand did not become painful as the intention and it became easy.Although I think that the
price is a little high, I think whether to be good goods.
View detail
Fits: BMW F800R, BMW F800R, BMW F800R, BMW F800ST, BMW F800S, BMW F800GT
An authentic positive one thought that it was uneasy at the little of a crawler bearing area, and it attached it. It is the touch which became large about 3 times.It is not buried even if it stops on the road surface of ground. atta
An authentic positive one thought that it was uneasy at the little of a crawler bearing area, and it attached it.
It is the touch which became large about 3 times.It is not buried even if it stops on the road surface of
ground. attaches and easy.There is no dissatisfied point and it is a good Parts!
View detail
Fits: BMW R1200R, BMW R1200RT, BMW R1200RT, BMW R1200R, BMW R1200ST
It completes in attachment easy 5 minutes. A setting face product increases and can stop in comfort. As for one point being worrisome, if the Handle has been Set in the state where took out the Side stands and it stopped, a car body will
It completes in attachment easy 5 minutes.
A setting face product increases and can stop in comfort.
As for one point being worrisome, if the Handle has been
Set in the state where took out the Side stands and it stopped, a car body will shift ahead in a motion of a front wheel, and a Side stands will become
Folded.
The
Handle had set, and it came out, and became that it is likely to push down repeatedly.
Since it got used now [
], it is satisfactory, but only it is dissatisfied.
View detail
Fits: BMW R1200GS, BMW R1200GS, BMW R1200GS Adventure, BMW R1200GS Adventure
Since I wished to bring a Handle to feeling this side, without changing a Position a lot, it is satisfied. The amount of money also has moving width with last thing, and that of the Manufacturer besides was keeping it at arm's length. Although it i
Since I wished to bring a Handle to feeling this side, without changing a Position a lot, it is satisfied.
The amount of money also has moving width with last thing, and that of the Manufacturer besides
was keeping it at arm's length.
Although it is 167 cm in
we height, just this Kit is enough.
View detail