- Home
- Product reviews
- Search reviews
- Motorcycle Parts
- Brakes
- Breeder Cap
Reviews
To Refresh!
[How is it used?
I purchased this because the Cap had become crusty and decayed over time.
The Release part of the Clutch was replaced.
How was your experience with it?
It is new, so it is soft and tight.
And with bremboLogo, the tension is increased.
How did it compare to other products?
There are other cheaper Caps and such, but if it is only a few hundred yen difference, bremboCap is the way to go!
And it is a reliable Manufacturer.
[Points to note]
I will remove it properly from now on when I bleed air.
View detail
Can also be used for four-wheeled vehicles!
The Bleeder BoltCap for the front caliper on my car (MINI JCW) was shredded, so I bought one or two to try and replace it.
The OEM was quoted a whopping Gold price of 1pc.1000 yen, so we were looking for a replacement and found that JCW's Caliper was made by brembo.
I bought the Brembo BoltCap on Webike, and it is Reasonable!
Less than half the price of MINIOEM and it comes in two. It's great! Thanks to brembo, we can use the same caps for both cars and motorcycles. So you can also use it for your 4-wheeled Brembo caliper!
I would like to see the Akebono opposed 4POT for Nissan cars learn from this.
View detail
For Brakefor Clutch Master
The cap for the air breeder of the GALE SPEED brake master cylinder was missing, so I bought one for Brembo. The for Brembo has a ring that goes through the air breeder, so even if the cap comes off, it will not be lost. View detail