Reviews
Galaga Size and good portability!
I bought this product to carry with me on my touring. I used to use my phone or TaBrett's Light on country roads where there are no streets at night, but it was too dark and inconvenient, but this product has made it very comfortable.
The good thing about this light is that there is no switch button to turn on the light, just open and close the light. It also has a hook so it can be hung near the handlebar of a motorcycle, which is really convenient!
View detail
Cheap and solid
Used in Step WGN Maintenance of Transporter.
I thought it was slightly difficult to put in and out the Bracket, which determines the height, but if you apply Rub or Grease, there is no problem.
It is cheap and has a sufficient load capacity, so I think Sunday mechanic is good enough.
I should have bought the Rubber adapter (sold separately).
View detail
You can also grab LimitMotorcycle's Battery terminal.
Purchased because I am good at raising Battery.
The smallest terminal of the battery for LimitMotorcycle can also be gripped depending on its shape.
Monotaro's JumpCable has been bumped out of Clip's Crimp, so I'm hoping for more durability in the future.
Also, I'm glad that it comes with a Case.
View detail
Value for money and bright
Large, bright, and conveniently lit just by opening it in case of an emergency. View detail
It is originally for Vehicle, but can also be used for Motorcycle.
I originally bought it for four-wheel maintenance, but I also use it for Motorcycle Lift up.
Although it is compact, it is designed to withstand 1 ton per pc, so it is stable and Brown.
When I raise the front or rear of my personal Level Motorcycle to remove the Three-Pronged Fork or Swing Arm Link, I use a Side Stand + Pantograph jack instead of a Racing Stand or Front-up Stand (a common technique in the Off-vehicle world, although some people may not be aware of it). (Some people may not know this, but it is a common technique in the off-car world.) However, when lifting a heavy motorcycle on rough terrain, the Pantograph jack alone is unstable and may come off.
In particular, frames without underframes are difficult to capture the center of gravity, and if the crankcase alone is used to support the frame, there is a possibility that the case will crack.
The Pantograph jack is then gently raised by placing it against a crankcase (while curing), and supported by an engine mount using our Jack stand while placing a block or the like underneath. Just like a four-wheeled vehicle. "Uma." The use of the product as a
As mentioned at the beginning, this product is quite Compact and does not take up FootSpace.
It is not the typical folding type, so it will not fold, fall over, or break even if it is set up a little roughly.
It also has a good amount of raising width, and is a very easy-to-use product, even when viewed purely as a Jack stand.
When stored, it can be made into a small size by alternating the two sides.
It is good to have it because it is useful for something in Motorcycle maintenance.
View detail
In dark and hard to see places!
When looking inside the Engine room under the Seat of the SuCUB, there are places that are difficult to see even in daylight, so this MobileLight is the solution. This MobileLight is easy to use:it can be placed, hung, or attached with a magnet. It can be used for 18 hours with 3 AA batteries, so I think it will last for a long time. It is inexpensive, but it is brighter than a flashlight and very useful. View detail