Reviews
Thin, lightweight, compact, easy to carry, and safe to carry
It is thin, lightweight, and very compact when folded, making it a must-have when I go out. It is very useful from spring to fall when the temperature difference is very large, such as when it is cold in the morning but hot during the day, or in summer when you are in a high altitude and the temperature is low, or when you encounter chilly conditions such as fog. In winter, it is good to have one more layer when you don't want to be overdressed but are a little worried about warmth.
It is more of an Emergency product, and if you expect to wear it in the inner room, the texture and design are like this, but the performance is sufficient for your needs.
Actually, I have been using a collarless version called "YKM-212" by Yamashiro before I bought this one. I bought this one because it is more compact when folded up, and this one with a hood seems to have good windproofing properties around the neck.
On the other hand, this model with Hood is designed for outer wear as well.
The Level is not a good place to stay in Parenthesis, but it is not embarrassing to take off your jacket and walk around during a break.
There are many thin, windproof innerwear products of this type, but I think that Yamashiro's silayed Nylon is the thinnest, lightest, softest, and most compact. I think it is the thinnest, lightest, softest and most compact. It is a recommendation for those who want to keep their luggage to a minimum. However, the price of this Hooded bag is a bit expensive. (List price) I would not say that it is a bit cosy.
Sorry WeBig, but if it's the lowest price sold at another Site, the cosmetics are good.
View detail
It's cheap, so it's good.
I purchased this for a DL1000 V-STROM 800 vehicle with Rear box.
I have the impression that the sewing quality is not so good and the fabric is thin, so I am concerned about its durability, but since it is inexpensive, I will use it as if it were a consumable item.
Although it has a buckle for wind protection, it cannot be tightened until it is firmly attached to the body, so it will flap around. This is a cause of concern, as it can lead to body wounding.
View detail
It is intended as an alternative to in-vehicle tools and for emergency use on the road.
The ZX-6R has an on-board tool storage compartment in the back of both the Tandem seat and the optional Single seat cover, but to use it, the storage bracket must be removed with a Hexagonal Wrench. It is very inconvenient though it is appreciated.
Since the servo motor of the exhaust device was removed to replace the external Slip-on Silencer, we decided to use the space to enhance our on-board tools and purchased this Compact with a minimum of tools.
For suspension setting, the Rear rebound damping force cannot be adjusted here, but I don't think this is a place that needs to be changed frequently in terms of usage. I have made a judgment on this.
Front can be used for each adjustment point.
I think it is better to prepare proper tools for daily maintenance, but I think it is better to separate it from emergency use on the road.
View detail
Fit feeling is good.
Installed on a PCX125.
We have used NeopreneType before and were very comfortable with it, so we decided to use the same Material this time as well.
However, the thickness of the part that operates the Blinker switch (left hand thumb) has been increased to improve durability.
I preferred the previous thinner one for ease of operation.
View detail
We have all the Size you need.
I was worried about E-Value Tap dice set EV-20TD 20PCS, which is often sold at Home center in the same price range.
I bought this one because there are 2 Pitch size Tap and Dice each in M10 and M12.
The fact that it is also sold by Yamashiro is another reason for its selection.
I am a little hesitant about this type of tool unless it is a product sold in stores.
I immediately expanded the screw holes in the Fog Lamp from M5 to M6 and used it to clean the screw holes in the Large and Under Guard. Of course, Dice was also used to clean the screws.
View detail
To avoid damaging the floor with the Transporter
I purchased this as a Side Stand receptacle when transporting a vehicle by Transporter.
This is not a problem if the vehicle has a well-machined floor, but when Tie Down is applied with Side Stand on a carpet floor, if the Tie Down is applied too tightly, the STAND will again dig into the vehicle floor, damaging the floor.
To prevent this, the floor is less likely to be damaged because the pressure is dispersed when such a board is laid down. Also, it is possible to apply a firm "Tie Down" even on soft floors such as carpet.
Basically, I leave it loaded in my car and use it when I use Transporter.
View detail
Convenient
Purchased for Mold prevention, deodorization, and moisture control
The prices are reasonable, especially for the Jet Helmet, the
If you have more than one full face
It is very recommendation when storing
There was one for Wear.
It looks like that one is no longer on sale.
View detail
Currently being utilized in a gravel parking lot at a Touring destination.
If it is available, we will use it, if not, we will devise a way to stop it, but we can stop it without much concern.
A conspicuous color is recommended to prevent misplacing them.
View detail
It is for Motorcycle use only and has a full range of Size
[How is it used?
I bought this to clean up the Screw Lock agent and to prepare the Yamas that were getting crushed when I removed and installed the Bolt for maintenance.
Bolts used in Motorcycle are often finer than standard bolts and will not fit in a standard tap dice.
This product is tailored specifically for Motorcycle and can be used with many Bolts used on Motorcycles.
Was the one you received as per Image?
[Contents] and Package were as shown in the image.
How was your experience with it?
As per its intended use, it functions well enough to clean screw yamas and prepare yamas.
Even if it is not cleaned in one round trip, it will be cleaned after repeated repetitions.
Closing the Nut after using it on both the Bolt and the Nut feels so good because it slips in just by hand. Cleaning it will allow you to tighten it with more correct Torque.
It can be said that it is cosmetically excellent to use this much for Bolt and Nut at this price.
[Points to note]
None
How did it compare to other products?
None
View detail
wiping off
Super absorbent ultra-thick Microfiber Cloth, purchased for cleaning.
Quantity:1 Set of 2pcs. Different colors on the front and back and thick, so it is easy to wipe off, and there is no worry about putting scratches, etc.
The price is not that expensive, so I would like to buy a spare next time.
View detail
Keep the inside of the Helmet clean!
[How is it used?
I always use it after running with full face helmet.
I bought it to replace my Helmet.
Was the one you received as per Image?
It was just as Image.
Although no one around me was using the product, I had seen various impressions and examined the product, so I had some understanding of the product.
How was your experience with it?
As I got older, Helmet left me with a different feeling than the smell of sweat, and each time I removed the interior and washed it, I was unable to get it back to smelling clean and nice.
I wanted to do something about it, so I bought a new Helmet with a renewal that I wanted to keep clean somehow, in conjunction with the purchase of a new Helmet.
I have been using it since then and always store it inside after use, even if it is not in the middle of summer.
Maybe that's why, some time after my purchase, there's been no change in the interior smell!
It is comfortable to wear every time.
[Points to note]
It seems that maintenance of SilicaClean itself is also needed.
It is also marked, so don't neglect it.
View detail
Fallen cannibals
When I am out on the road and the ground is gravel, or in Asphalt where the ground is softened by exposure to high temperatures, the STAND may sink and the motorcycle may tip over, so I keep it in my bag at all times. It is like an insurance policy, but it gives me peace of mind. View detail
Expect durability!
I used to use Poshu's Sponge type, but it broke after about a year.
I know this type of product is consumable, but I liked it because of its non-slip and thermal protectionMaterial:I bought this one from Rubber.
It's cheap, but the above two points are effective, and the only thing left is durability.
View detail
For those who are feeling the cold limit.
SR400 has a small battery capacity, and I was worried about using a grip heater, and was hesitant to use electric heating gloves because they are expensive.
So I bought this product to try it out and was impressed when I used it.
First of all, it keeps my fingers cool because they are not exposed to the driving wind, and it is waterproof, so a little rain is no problem. (However, it will soak through the cracks a little, so that the fingertips will be a little damp after 30 minutes of driving in the city).
The design is also cute, just like the Mitten that Red-chan does.
View detail
First Tap&Dice set!
[How is it used?
I use it to maintain my motorcycle! I hadn't used it before to clean Bolt and Screw holes with Beauty before, but now I use it on the Main to clean Disc Bolt and other parts that were coated with Screw lock material when I tighten them again.
Also, when I'm doing maintenance and the Bolt is hard to get in, I do both the Bolt and Screw holes as a shuffle before installing.
Was the one you received as per Image?
The product itself was just as Image! The size is also for Motorcycle, so it has all the size you need, which is great!
How was your experience with it?
It seems not to be suitable for a little hard usage such as using GunGun or cutting a screw mountain in a new base material.
We recommend that you use it only for Main, for example, to correct the actual object.
[Points to note]
As I said a bit earlier, I don't think the Material itself of this product is that authentic.
Hard usage may cause damage, so it's better to use it carefully.
How did it compare to other products?
Honestly speaking, I thought to buy Astro Products at first, but I picked up this one because the size of Yamashiro's motorcycle line up was excellent.
[Opinions and requests to Manufacturer
It's a cheap product, so it's probably a bad idea, but the package is too lousy.
Please make the package more considerate of storage! If not, it will become RoseRose and squishy, and sometimes I feel sad when I open the toolbox!
View detail
I feel like I'm drying out.
Even if you're wearing an Inner Cap and the inside of the Helmet is a bit damp due to sweat penetration, just put this inside and you'll be amazed!
The next day it is already dry.
It will come in handy in many ways, such as using it every day when you come home or during the summer.
Also, when the moisture-absorbing capacity reaches its limit, you can tell by the Sign, so you can use it again after drying it.
View detail
Convenient and helpful
As a motorcycle commuter, I thought it was inevitable that Helmet's Cheek Pad and chin strap would get wet and feel uncomfortable to the touch on rainy days.
This product claims to protect against sweat in the summer, but I hate how sticky the Cheek Pad and chin strap feels on my skin the day after a rainy day, so I bought this product hoping it would alleviate that.
If you put this product in the Helmet when you get home, the Cheek Pad and chinstrap will feel smooth the next morning.
I want to be able to get into Helmet when I get home year round.
I got a good deal.
View detail
Quality over price
The first thing I felt when I picked it up was that the texture of the fabric was better than I expected.
It is a Matte fabric with no sheen and seems to be durable while being Stretchy.
The storage bag is also made of a similar textured fabric that stretches and is easy to store.
Because I don't like running in the rain in the first place, I divided it into emergency use at the time of touring and bought it, but it seems to be able to expect enough waterproofness. (Because I am not blessed with the opportunity to use it yet, the actual waterproofness is unknown.
One point of concern is that there is no Ventilation. Breathability is a high number, but because there is no physical Ventilation, how far the steam escapes, this will be known when you actually use it.
I'm 168cm, 62kg, standard build, and I wore the size M. The pants are just right size, and the jacket is longer in the back. The jacket is longer in the back.
As shown in the image, the state of the storage, from 500ml pet to about 2 large, but I thought it was enough to carry Size.
View detail
Recommended for people who sweat a lot.
To the point where I was concerned for the summer because I use Full face where I am originally quite sweaty!
I bought this product because it had good ratings.
I put it in the Helmet after every run and it certainly dries well and doesn't smell after leaving it overnight.
Since cleanliness is paramount in these days, it is also recommended from the point of view of hygiene.
View detail
Rigid feeling
I've never used the more expensive ones, so I can't compare them.
I think that's good enough for me.
It seems sturdy and easy to understand when it comes to setting Torque.
Grip is also long and easy to apply force.
Also, there are clear instructions on the back of the Case on how to use it.
If you read and use it, you won't break it by mistake.
View detail