Reviews
Fit feeling is good.
Installed on a PCX125.
We have used NeopreneType before and were very comfortable with it, so we decided to use the same Material this time as well.
However, the thickness of the part that operates the Blinker switch (left hand thumb) has been increased to improve durability.
I preferred the previous thinner one for ease of operation.
View detail
To avoid damaging the floor with the Transporter
I purchased this as a Side Stand receptacle when transporting a vehicle by Transporter.
This is not a problem if the vehicle has a well-machined floor, but when Tie Down is applied with Side Stand on a carpet floor, if the Tie Down is applied too tightly, the STAND will again dig into the vehicle floor, damaging the floor.
To prevent this, the floor is less likely to be damaged because the pressure is dispersed when such a board is laid down. Also, it is possible to apply a firm "Tie Down" even on soft floors such as carpet.
Basically, I leave it loaded in my car and use it when I use Transporter.
View detail
Currently being utilized in a gravel parking lot at a Touring destination.
If it is available, we will use it, if not, we will devise a way to stop it, but we can stop it without much concern.
A conspicuous color is recommended to prevent misplacing them.
View detail
Fallen cannibals
When I am out on the road and the ground is gravel, or in Asphalt where the ground is softened by exposure to high temperatures, the STAND may sink and the motorcycle may tip over, so I keep it in my bag at all times. It is like an insurance policy, but it gives me peace of mind. View detail
Expect durability!
I used to use Poshu's Sponge type, but it broke after about a year.
I know this type of product is consumable, but I liked it because of its non-slip and thermal protectionMaterial:I bought this one from Rubber.
It's cheap, but the above two points are effective, and the only thing left is durability.
View detail
For those who are feeling the cold limit.
SR400 has a small battery capacity, and I was worried about using a grip heater, and was hesitant to use electric heating gloves because they are expensive.
So I bought this product to try it out and was impressed when I used it.
First of all, it keeps my fingers cool because they are not exposed to the driving wind, and it is waterproof, so a little rain is no problem. (However, it will soak through the cracks a little, so that the fingertips will be a little damp after 30 minutes of driving in the city).
The design is also cute, just like the Mitten that Red-chan does.
View detail
warmth first
As the title suggests, I tried many things, but it was the warmest I could stay in the Single Body It is
The windproof Warm Gloves without the Handlebar Cover will also keep your fingertips on the edge for an hour below zero I don't think the Lever Cover and Windproof Cover are perfect for sub-zero temperatures It is
With the help of electric heat, you can prolong the time a little, but if you can't completely prevent the wind from blowing, it will gradually cool down It will come
In that respect, the old Handlebar Cover has evolved in terms of material and usability You will need to change from Winter Gloves to All Seasons ones In addition, there were cases, not perfect, but in case of ordinary rain, Waterproof It's very comfortable and the Gloves don't get wet
I think that the extreme cold spec. can go quite well if you use Grip as an electric heat source, I think that the severe winter season is a necessity I think, it's a bit of a hassle and a bit of a drag, but it's the best countermeasure against cold It is
It's easy to put on, less expensive than other winter clothes, and provides good wind and winter protection
The operation of Blinkeretc. will be a little difficult, but I think that you have to get used to it I'm using it
View detail
Essential items in winter
Once you start using it, it is equipment that you can not stop.
Because there is no core, in CUB without Clutch lever, because it is recessed by wind pressure, it is used with Handlebar Guard.
View detail