Please login to check coupons
Product Detail
Specification
[Set components]・Step
・Bolt
・Nut
[Size]
■Backer
・Vertical: 62mm
・Width: 24mm
・Width approx:24mm
・Step mounting area:Width 12mm
■Step
・Total length: 105mm (not including mounting part)
・Diameter: 29mm
・Mounting area: Total length 28mm
・Mounting area: Width 11mm
Description
The model body of a stock step board is not allowed.
By adding this step backer, the step position is moved by 4cm.
If you think the dragster is a little too far for your legs, or if you don't want to go to the mid-con, please try it.
This is an original special part that makes it possible to install stylish machined steps used on Harleys and other vehicles.
Stock steps are not allowed.
The price of the backer itself is reasonable.
This kit is a full step backer kit including steps, bolts and nuts.
By changing the position, you can get rid of the dragster's too small bank angle, especially if you have it lowered.
Installation is very easy.
We have only a few left in stock for this hit product!
!!
By adding this step backer, the step position is moved by 4cm.
If you think the dragster is a little too far for your legs, or if you don't want to go to the mid-con, please try it.
This is an original special part that makes it possible to install stylish machined steps used on Harleys and other vehicles.
Stock steps are not allowed.
The price of the backer itself is reasonable.
This kit is a full step backer kit including steps, bolts and nuts.
By changing the position, you can get rid of the dragster's too small bank angle, especially if you have it lowered.
Installation is very easy.
We have only a few left in stock for this hit product!
!!
Caution
*Remove the OEM bolts and use the OEM bolts in the bolt holes on the vehicle body mounting side.*After installation, the levers should be adjusted slightly.