Product Detail
Specification
[Compatible range] P.C.D140-280mmDescription
■This product is a puller to remove the scooter swingarm from the final gear shaft.
This tool is used to remove swingarm bearings and final gear shafts that have been difficult to remove due to rust and other factors, improving work efficiency.
■Used to remove and install the swingarm of scooters
■With a protector to protect the shaft
■Assembly in accordance with the step of the suspension part
■Special bolt to withstand high torque
■Remove the axle nut and check if the swingarm can be removed by hand.
■Tighten the puller bolt after confirming that each part has been assembled securely.
[Procedure]
[1]Remove the axle nut and check if the swingarm can be removed by hand.(Scope of Application: P.C.D up to 140-280mm)
[2] Make sure that each part is securely assembled and tighten the puller bolts.Bike assembly: PCX125
This tool is used to remove swingarm bearings and final gear shafts that have been difficult to remove due to rust and other factors, improving work efficiency.
■Used to remove and install the swingarm of scooters
■With a protector to protect the shaft
■Assembly in accordance with the step of the suspension part
■Special bolt to withstand high torque
■Remove the axle nut and check if the swingarm can be removed by hand.
■Tighten the puller bolt after confirming that each part has been assembled securely.
[Procedure]
[1]Remove the axle nut and check if the swingarm can be removed by hand.(Scope of Application: P.C.D up to 140-280mm)
[2] Make sure that each part is securely assembled and tighten the puller bolts.Bike assembly: PCX125
Note
* The image is only for reference. The image shown may differ from the actual product.
Model Page Links
Review
0.0
/ 5
(0 Review)