Please login to check coupons
Product Detail
Specification
[Installation difficulty] 3[Length] Approx. 1330mm
[Pipe diameter] 25Φ
[Load capacity] 10kg per side
Previous part number: OGP019-S (New part number: OGP031-S)
Description
Expanding the possibilities of cargo space
The "multi" pipe rack
It is a pipe rack that attaches to the side of the luggage room for convenience.By using the clip part that fastens the ceiling lining, the attached turn nut is embedded and the specially developed bracket is attached.Pass a pipe through it and fix it with an immersion screw, and you are done.
It can be used to hold a rod holder, a room carrier, or to hang clothes.It's sure to become a must-have item for your racing trailer!Remove the pins that fasten the ceiling lining by using a lining remover.Use an electric drill to widen the original hole in the body.Be careful not to damage the outside of the body by accident.Insert the supplied turn nut into the widened hole.The specially developed bracket is temporarily fixed with bolts and turn nuts.Pass the pipe through the bracket and fix it with the set screw attached to the bracket.Tighten the bolts securing the bracket to complete the installation.The upper part of the sliding door is too narrow to install the turn nut, so the supplied clip nut is installed.Some drilling will be required, but it will look like the stock one with minimum modification to the body.
The "multi" pipe rack
It is a pipe rack that attaches to the side of the luggage room for convenience.By using the clip part that fastens the ceiling lining, the attached turn nut is embedded and the specially developed bracket is attached.Pass a pipe through it and fix it with an immersion screw, and you are done.
It can be used to hold a rod holder, a room carrier, or to hang clothes.It's sure to become a must-have item for your racing trailer!Remove the pins that fasten the ceiling lining by using a lining remover.Use an electric drill to widen the original hole in the body.Be careful not to damage the outside of the body by accident.Insert the supplied turn nut into the widened hole.The specially developed bracket is temporarily fixed with bolts and turn nuts.Pass the pipe through the bracket and fix it with the set screw attached to the bracket.Tighten the bolts securing the bracket to complete the installation.The upper part of the sliding door is too narrow to install the turn nut, so the supplied clip nut is installed.Some drilling will be required, but it will look like the stock one with minimum modification to the body.
Caution
*Images may contain other types.*This product does not fit Toyota Modellista MRT.
*Please note that depending on the timing of your order, you may receive the old part number.
*There may be changes in product specifications due to the manufacturer's reasons.