Temp meter stay "Marumie-kun" YOSHIMURA PRO-GRESS [Progress] Multi-temp meter support
- Product number: BG-TMS-Y02-BK
Please login to check coupons
Product Detail
Specification
[Spec. ]Material:Aluminum/Black Anodized Specification[Product Contents]
BracketBody
・M8X10mmBlackAluminum Collar X1
・Stainless Steel Cap BoltM8X30mm X1
Description
It's definitely better to have a full view!
The development of this product began with a single word:"Temp meter stay" by Bagus!.
The theme of this year's Oil Temperature GaugeBracket is
Bagus! It can be installed in the center of the Stem Kit as much as possible, and the design should be as small as possible in the refreshed design, the collar should be as small as possible, the bolt nut should be minimum, and above all, the oil temperature display should be in full view!
Under such a concept, YOSHIMURAProgress1 and Progress2 are completed!
Product Contents were also reduced to the minimum and the reduction in cost was also successful!
This Temp meter stay easy to read and display as Refreshing.
Please try it!
The development of this product began with a single word:"Temp meter stay" by Bagus!.
The theme of this year's Oil Temperature GaugeBracket is
Bagus! It can be installed in the center of the Stem Kit as much as possible, and the design should be as small as possible in the refreshed design, the collar should be as small as possible, the bolt nut should be minimum, and above all, the oil temperature display should be in full view!
Under such a concept, YOSHIMURAProgress1 and Progress2 are completed!
Product Contents were also reduced to the minimum and the reduction in cost was also successful!
This Temp meter stay easy to read and display as Refreshing.
Please try it!
Caution
*Loosen the bolts on the stay body to install the meter. A 2mm hexagonal wrench is required for assembly. (For M3 cap bolt)*M8 collars and 30mm bolts are included for installation, but they are general-purpose products. If the length of the included parts does not fit your vehicle, please change the length of the collars and bolts to fit your vehicle.
*Basically, it is based on the "Bagus! Offset Stem Kit". If the pitch of the handle clamp is 85 to 90mm, it can be mounted almost at the center. Please refer to the following table.
*Other types and products are included in the image.
*Please note that the product specification may change due to manufacturer reasons.