Accessory Power Connection Kit and Sub Harness
- Product number: XEL910HANS1
- ENDURANCE
- |
- 4.0
- (1 Review)
Please login to check coupons
Product Detail
Specification
[Material]Case body: Aluminum (black alumite)
[Dimensions (approx)]
Main unit: 22.3 x 37.8 x 36.5
Bullet terminal: Φ3.5
[Components] (Refer to the instruction manual)
・Accessory Power Supply Connection Kit x 1
・Sub Harness x 1
[installation time]
Depends on the vehicle
6 months (or up to 5000km of riding after installation)
Description
[Universal accessory power connection kit can be installed without wiring modification!]
You can easily take out three accessory power sources linked to the vehicle key ON, and the size of the main unit itself is very compact and waterproof, so you don't have to worry about the installation place.
The rated outputs of the three accessory power supplies are 7.5A x 2 and 5A x 1 (total 20A) respectively, and PTC thermistors are used inside.
High output is realized by taking power directly from the battery.
・Length from the unit to the bullet terminal: Approx. 250mm
・Length from the main unit to the battery connection terminal: Approx. 1300mm
・Length of the accessory power supply bullet for the relay from the main unit: Approx. 1300mm
You can easily take out three accessory power sources linked to the vehicle key ON, and the size of the main unit itself is very compact and waterproof, so you don't have to worry about the installation place.
The rated outputs of the three accessory power supplies are 7.5A x 2 and 5A x 1 (total 20A) respectively, and PTC thermistors are used inside.
High output is realized by taking power directly from the battery.
・Length from the unit to the bullet terminal: Approx. 250mm
・Length from the main unit to the battery connection terminal: Approx. 1300mm
・Length of the accessory power supply bullet for the relay from the main unit: Approx. 1300mm
Caution
*PTC thermistors are cut off by the heat of the current, and become very hot depending on the amount of current and elapsed time after cut off.In this case, it may deform or melt the main unit, which is very dangerous. Remove the interrupted device from the main unit as soon as possible.*Do not install in a place where heat is likely to accumulate because the main body generates heat.
*The main body is waterproof, but the terminal part should be treated so that it is not exposed to water.
*The output power is as high as 20A, but not all vehicles can be used with 20A.Depending on the vehicle, battery condition, or other factors, the load on the battery may increase, which may cause the battery to run out of power.
*The color of the product may vary depending on the shooting conditions, monitor, product lot, and left and right of the set product, but returns or exchanges is not accepted.
*Connecting parts such as crimp terminals are not waterproof.
*Connection to the accessory power supply for the relay is required.
*Please check the wiring diagram of the vehicle and confirm which terminal of the brake lamp switch is to be interposed before installation.
*There may be changes in product specifications due to the manufacturer's reasons.