Please login to check coupons
Product Detail
Specification
[Size]Center of mounting hole - length of center: Approx. 375mm
Spring length: 205mm
Spring Outer Diameter: 65mm
Spring wire diameter: 8.1mm
Rod diameter: 12.3mm
Inner diameter of Upper Mounting Hole: 14mm
Inner diameter of lower mounting hole: 10mm
Thickness of the upper mounting: 18.3mm
Thickness of lower mounting: 20.0mm
Tank Diameter: 49mm
Description
●Based on the concept of providing a suspension that can be used with assurance, this is an original suspension that has been completed through many trials and errors from planning and development to commercialization.
●In order to achieve low cost, the parts that make up the suspension are manufactured at partner factories overseas, while the final assembly, nitrogen gas injection, product inspection before shipment, and other important tasks are handled by specialized staff at U-CP's factories in Japan.
●U-CP has increased the tank capacity, increased the spring wire diameter by 1mm, and increased the spring outer diameter by 5mm, so the ride will not be too soft and fluffy.
●The upper and lower rubber bushings are manufactured in Japan, so they are resistant to deterioration and can be used just like the stock.
●The length of the installation hole is about 375mm from center to center, which is about 1cm longer than the stock suspension.The end eye can be extended by 10mm.
●The spring preload can be full adjustable.
●Damping pressure cannot be adjusted.
●The preload adjustment wrench and hex wrench are included.
●In order to achieve low cost, the parts that make up the suspension are manufactured at partner factories overseas, while the final assembly, nitrogen gas injection, product inspection before shipment, and other important tasks are handled by specialized staff at U-CP's factories in Japan.
●U-CP has increased the tank capacity, increased the spring wire diameter by 1mm, and increased the spring outer diameter by 5mm, so the ride will not be too soft and fluffy.
●The upper and lower rubber bushings are manufactured in Japan, so they are resistant to deterioration and can be used just like the stock.
●The length of the installation hole is about 375mm from center to center, which is about 1cm longer than the stock suspension.The end eye can be extended by 10mm.
●The spring preload can be full adjustable.
●Damping pressure cannot be adjusted.
●The preload adjustment wrench and hex wrench are included.
Caution
*The image is for reference only.The size of the collar may vary depending on the model.*There may be some small scratches on the product during production or transportation.