Please login to check coupons
Product Description
Compatible with handles with an inside diameter of 17.9mm-18.5mm
Specification
Description
Base part is high-strength Aluminum Alloy GoldMaterial(A6061-T6)Cut-out,Anodized Finishing.
Material:Plastic guard with high strength and flexibility.
Caution
*There are cases that the color of the photo on the photo and the actual product are slightly different due to monitoring environment etc. reasons.
*The attached photo is for reference only, and there are cases that it may be different from the color of the product.
*The price and specification for this product are subjected to change without prior notice.
*Please note that the product specification may change due to manufacturer reasons.
*There are cases that it contains other product in the photo.
/ 5
Installed on a GSX-R1000R 2019This is SSKSpeedra's Lever Guard, in which I personally have full confidence.Although some people purchase Lever Guard expecting it to protect them in the event of a fall due to its appearance, it is originally intended to prevent the Brake lever from being pushed in and unexpectedly braked in the event of contact with another vehicle in a race scene, rather than to protect them in the event of a fall.Therefore, it is not inherently strong enough to protect Lever from the weight of the vehicle body.So, for those of us who don't run circuits and don't race, we originally purchased it for the purpose of looking like a SS.The comparison was made with YOSHIMURA under the sun.That one is a bit pricier than this one, but the design is more sophisticated.Guard part is Material:Plastic, with a few reviews here and there saying that this section is a bit too weak.On the other hand, this one is slightly cheaper and the guard portion is Dry carbon.However, this may limit the degree of freedom of shape, and the design is a bit large and ungainly.I had a hard time deciding, but in the end I chose this product because of the dry carbon.The result is satisfactory.It is rigid enough to provide protection in the event of a fall, perhaps thanks to its wildly Largeness.The guard portion of Dry carbon is also quite firm, and does not flex even with a little force applied with the bare hand.If there is a caveat, vibration may be a concern because of the obvious lighter weight relative to the OEMBar End.Also, the bolt that fastens the body to the handlebar is not included and must be replaced with an OEM bolt.In the case of R1000, the Bolt is 10mmHEX, so it is not a Bolt that can be so nudged, but it is a place where it often sticks, so care must be taken not to damage the Bolt.However, the installation is Bolt1 pc, so I think even beginners can install it easily. View detail
I've bought a lot of Speedra products and this Lever Guard was not very good.The Carbon on the front side is very well finished, but the Reverse side is terrible. Every time I looked at the Lever Guard while driving, I was disappointed with the poor finish and the difference in finish.I sprayed Clear 3 times to make it better and installed it.The Weight and Screw in the Handlebar didn't match the installation.I got a screw from Home center and installed it, but the screw hole is too large and it shifts.I was able to install that too with a little work.It was a hell of a Lever Guard.(a) littleI can't UpRoad photos, so no photos. View detail
nice
I like it very much, the gloss is very beautiful, the aluminum alloy part is very thick, if it is made of carbon fiber, it would be better View detail
The part of Carbon also seems to be firm. As for the part which I am concerned about, is it good or bad that Bar End is light because this product is Aluminum while NORMAL is iron? I'm curious. View detail