Wide Stand
Product number: 65-86-01
฿3,611
Please login to check coupons
Product Description
Ninja ZX-25R SE 20-22
Ninja ZX-25R 20-22
Ninja ZX-25R SE 23-
Ninja ZX-4R SE 23-
Ninja ZX-4RR 23-
Specification
anodized aluminum finish
Description
It is especially useful when parking on loose ground or heated asphalt.
Approximately 3 times the area of the ground surface of the stock side stand.
The stand is not only wider, but also more resistant to tipping over by extending the tip outward while maintaining the width on both sides.
Caution
/ 5
I was going to settle for a cheap wide stand from an unfamiliar Manufacturer.We chose this one because we were notified of its release by Over, a safe and reliable company.The ground contact surface is firmly level with the ground, and there is only a gap that may or may not contain a sheet of cardboard.(The photo above shows the gap, but it can be narrowed down a little more after adjustment.)It was expensive, but I liked the satisfactory workmanship.I chose the Powder coat one to avoid flying gravel.The color is close to the paint of the OEMSide Stand, which is nice without looking bad.However, two points should be kept in mind when installing the system.1. side stand must be installed with the side stand raisedThis product has a slight rattling to absorb errors on the car body side.As mentioned in the Instruction Manual, fine adjustment of the mounting position is required before tightening the Bolt.In this case, the Side Stand needs to be adjusted with the Side Stand raised.Assuming that one person installs the handlebar, he/she will work while squatting and holding the handlebar with one hand.If you tilt out of balance, you will have two choices:you will be caught between the Motorcycle and the Exhaust System, or you will be knocked over to the Exhaust System side.We recommend using a Maintenance Stand or working with two or more people, butWhen working alone, put it in 1st gear and use Brake Lock as shown below to stabilize it.DAYTONA:Front Brake Lockhttps://www.webike.net/sd/21825075/2. low specified TorqueI use M5 and M6 Bolt to fix it, but the tightening Torque is specified to be less than 10nm.This value cannot be set for some types of torque wrench. (Especially if it is for suspension, it may be too severe.)The Bolt is tensioned so that it is relatively difficult to loosen, butIt is recommended to adhere to the specified Torque + use Threadlocker in combination.Since the base material is aluminum, experience has shown that it licks easily when tightened by intuition.Since no other parts need to be removed during the installation processIt is a relatively easy component to install.It is expensive and Bolt can be loose and dropped.Be careful not to ruin it. View detail
I really like the quality and finish of the product... It doesn't fit my hunter curve. I searched and purchased it, but this was the first time I realized that there were separate markings of 55 and 65 in the model name. Perhaps it was for domestic use or for export, but it did not fit the Korean stand. That's too bad. -------------------------------------------------- -------- I really like the quality and finish of the product ... It doesn't fit my hunter curve I searched and purchased, but I first learned whether there were 55 and 65 notations in the model name. It was not suitable for the Korean stand, whether the domestic export was wrong. That's too bad. Powered by Google Translator View detail
First of all, the delivery is very fast Product condition, packaging condition, finish, etc. I like it so much And the manual was also well packaged. I wish you all the best in the future... ... ... ... ... ... ... ... ... ... ... ... ... ...------------------------------------------------------------- ----------- First of all, delivery is quietly fast Products, packaging status, finish, etc. I like it so much And the manual has also been well packed Thank you for your future ... Of Of Of Of Of Of Of Of Of Of Of Of Of Of Of Of Powered by Google Translator View detail