Brembo 2 POT Rear Floating Kit Type-I Full Option Set
Product number: 30876
4.3 (3 Reviews)
฿20,521
Please login to check coupons
Product Description
Zephyr 750
Zephyr 750
Specification
・Machined caliper support
・Machined torque rod
・Torque Rod Mount (or Torque Rod Mount Plate) Main Unit
・Stainless Steel Fitting Brake Hose
・Copper crush washers
・Banjo Bolt for Brembo
・Brake fluid
・Brembo master cylinder
Description
A rear brake kit that combines Brembo 2-pot calipers with machined caliper supports and machined aluminum torque rods mounted on the frame.
This is a full option set that includes all the necessary parts for installation and even includes a Brembo master cylinder kit.
Once installed, this is a complete set of calipers that can demonstrate the full performance of Brembo calipers in terms of control and braking power.
Caution
*The image above is for GPZ900R.
*The air will not be completely released when the caliper is in the downward position.As shown in image 5, be sure to move the caliper to the upper part of the disc and temporarily fix it with cable ties to prevent it from falling before releasing the air.
*Please be sure to bleed the air with the brake disc in between.
*Whether to install
Exhaust series
・PMC, Midnight, Moriwaki, etc. exhausts and short tubes: Available (The torque rod mount plate needs to be installed in the mounting hole of the exhaust bracket that is currently installed.)
・Z racing exhaust: (If the exhaust is removed, it can be installed.)
Swingarm
・Swingarm with sway bar: (Extend a rod about 15mm in diameter straight out from the surface of the rear disc of the wheel currently installed, about 15mm out from the surface, to the front of the swingarm.You can install the stabilizer if it does not interfere with the bar.)
・ZRX400 swingarm: Not available
*In the case of stock wheels, there may be problems due to compatibility, but aftermarket wheels can be installed without problems.
・ZEPHYR 1100 stock wheels: Need little adjustment
・ZEPHYR 1100RS stock wheels: 〇
・ZZR1100C stock wheels: Need little adjustment
・ZX-10 stock wheels: Not available
・GPZ1100 stock wheels: Not available
Not available: Not fit.
△: It can be installed by cutting the back side of the caliper.(See image 6)
Available: It fits fine.
-
KAWASAKI
/ 5
It's been a while since I received it, but I had it put on at the store and the Brake works much better. I am quite satisfied. I would like to use it again if I have the chance. View detail
I've had SpecificationsEngineerRing's rear brake kit installed for about 10 years now with no problems, and I'm still using it. It obviously feels better than the OEM. View detail
You are attentive.You can change Rear's Brake around with Total, so when you change to brembo, Caliper, MASTER did it all at once.Design is also Refreshing and I like it. View detail