Motorcycle Stand/Lift Jack
Product number: ca0514
฿4,288
Please login to check coupons
Product Description
DAXetc.
Universal
Specification
・Maximum lift height: 400mm
・Minimum lift height: 95mm
(Lifting capacity including saddle height: 150-485mm)
・Platform: 450mm x 150mm
・Weight: Approx. 15kg
・With two types of saddles for fine adjustment (high type and low type)
・The saddle is coated with rubber to prevent damage to the vehicle
Description
Recommended for chain maintenance, tire changes and other maintenance!
Compact but very stable!
Maximum weight is available up to 500kg!
For lifting up and down, you can use the special crank included in the package or you can operate it with power tools.
The jack and the saddle where the frame is placed are coated with rubber to prevent the frame from being scratched.
The spacing and height of the saddle section can be adjusted to the width of the bike.
Hi type and Lo type saddles are included in the package, so please use them according to your model.
[Instructions for use]
Set it under the vehicle body and turn the handlebar.
Caution
*When working, be sure to take measures to prevent the unit from tipping over, such as fixing the unit to an anchor to prevent it from tipping over when jacked up.
*There are some scratches and blemishes because it is an imported product.
*There may be changes in product specifications due to the manufacturer's reasons.
-
HONDA
/ 5
When using cb1100RSMORIWAKIShort Tubewithout Center Stand, the exhaust system will be interfered if the longer attachment is not used. In the side stand condition, the jack with the longer attachment will not fit, so it is a bit dangerous to put the jack in the right position while raising the motorcycle by yourself. It is not recommended to use it in the same way as I do, because the positioning is very troublesome. View detail
I was able to lift my heavy BMW K1200RS without any problem. It is very stable and the cost performance is great.It is quite heavy, but I think that contributes to its stabilization. View detail
In the past, chain maintenance was done with the rear wheels on the roller stand, but the parking lot is slightly sloped and the rear wheels would gap from the standenter as they were being turned, making it very hard work.This Lift made ChainMaintenance a breeze!It is for use on a DragStar 250. When I received the product and saw it, I wondered if it would fit under the frame. But it went in without any difficulty.The price is reasonable and the product itself is solid.This was a good purchase. View detail
I used it to remove and install 1200CX Front wheel.I had considered a very inexpensive STANDJACK similar to this product, but many other reviewers had criticized it for its lack of rigidity, etc., so I decided to purchase it from the trusted Webig.I have been using Pantograph jacks, so the stability of the car body during jack-up is completely different, and I can start work without worrying about work accidents.It should be noted that I can now easily insert the Axle Shaft of the front wheel, which I had difficulty with before.I wish I had bought it earlier because it can be used not only for DoubleCradleFrame but also for Twin spar frame cars. View detail
It can be used effectively for motorcycles without a center stand.They easily lifted the heavy body of the vehicle.The work in general, including the replacement of the rear suspension, was done smoothly. View detail