GSX1300R GSX1300R HAYABUSA(GSX1300R HAYABUSA) 08-10ดูเพิ่มเติม
The price is reasonably expensive, but both quality and accuracy are satisfactory enough. It was supposed to be easy to install carefully, but Bush and Instruction Manual for reverse change were in the corner of the box and I did not notice, it was a hard fight until I found out what, after finding I was able to install SUG without problems. I think that it is better for Instruction Manual and Bush to put it in a place that looks better (Lol).
Because the footpeg position moves 10 mm above and 50 mm later, it does not mean that the knee bending becomes too tight so it gets a better fit and a sense of security than OEM Position. Since it was in a state that the item was temporarily assembled already, there was no difficulty in installation. However, in INAZUMA 1200, Shift Pedal and Side Stand footrest overlap, and if you perform a Shift operation while running it will interfere. I do not have anything to do with the ironing stick, so it is okay if I bend it.
ZX-10R (2016) I wanted to make a reverse change, so I tried looking to purchase Rear Sets, - I can do both reverse changes. " "Rear brake's OEMLamp switch can be used" We did not hesitate to buy Rear Sets which can meet the personal request of.
Installation is not difficult, but it will arrive in the state of temporary group, so decompose in advance - Grease up to sliding part - This pair (Only in places where there is no problem even if fixed in advance) I think that you had better finish. Also, Heel Guard is not independent, so when installing Heel Guard to avoid scratches Motorcycle Dustclothetc. We recommend you to protect with.
Position can not be selected only four points, but since the original Position is tight, I think no particular problem if it is not people who want to fine-tune. Since footpeg also takes longer than it looks, you can safely hang off in Circuit driving. Also, I felt Shift and Brake became easier.
I think that the appearance has overwhelmingly improved, so it is not cheap shopping, but I am satisfied.
That's why it's not a bad product, it's a very good product.
Because of the expensive price, there are no people who are wearing it.
If you like On Lee.
Usability and ease of installation are as stated by everyone.
Dare to say, Screw part of Change rod is easy to rust so be careful.
Bolt is also somewhat licking cheap.
As early as thinking about Titanium Bolt.
Impression after replacing. Shift feeling and car body Quantity : Pair (for Left and Right) I feel that operability such as stiffness when switching is improved. However, although deliveries are provisionally assembled, I think that attention is necessary. The bush bar color of Brake department is provisionally reversed, the instruction manual is ambiguous, and the publication photograph is mono black - Copy, failed after installing as temporarily assembled.
Once I get the point, I do not think there is no Brown - -. I could replace it with Smooth on the Shift side, but when I ran 100 kilometers, I could get a Screw holding PedalLever.
I tried again with Screw lock agent.