Cracked in Side cover of VTR so I was looking for Carbon Seat for repair and Dress-up. To evaluate this product "extend" I wrote that it was expected and purchased. When I got the item I thought that the coloring is now unified, but when it became the actual sticking stage I thought that it was tough because I could continue to stretch with Dryer and stretch it to match the Curve. Regarding coloring, even if it roasted and extended with a considerably Dryer, I was able to concentrate on the task of putting it at ease because there is no change and it is stable.
I bought it for Normal parts, seeking astringency and luxury.
This time, challenge Front fork guard.
It took 1 hour to Cut, about 1 hour to paste, but it made it a satisfactory finish.
When sticking, as with pasting of Decal, using soapy water, the R part took effect while drawing air with your fingers while applying Dryer.
There was a slightly weak impression on stickiness, at the edge Limit Cut there was a part that would float as time passed, so when you cut it it's not Limit, it's better to see a margin of 2, 3 mm.
Feeling of delicious texture and Cost do not touch and feel free Carbon "Wind" It was very satisfying that I could convert it!
What shall we do with the faded Side cover?
Even if it gets painted it will peel off quickly and painting each time is troublesome.
Let's polish thoroughly and shine glossy?
I changed Fender and because the color is different.
Sticker sticky sticky, should I fake it?
No, I do not want to make it so lively. I thought so.
Better yet, I'll stick it over!
Peel off paint and Decal that remained in Cover, sharpen it and sharpen it with a fine sandwich.
Once the substrate has been formed, degreasing and removing.
Outline Plus Cut roughly the portion of folding back, and then stick together while sticking, while sticking the actual items together.
Durability is not high because it is not so thick and soft as Dryer's heat even about the heat.
But, I was satisfied with the beautiful paste.
The coolness of Carbon is oozing, and the place where I put it beautifully is in a state that it does not look like it stuck at all.
Because I was an amateur, I could not stick it beautifully.
I think that it is completely unknown if a delicious person cuts and pastes it.
I felt it difficult for beginners.
The setting color of DRC MOTOLED Flasher Holder Plate used only Titanium color with Blue and Titanium color, but I felt that it was floating once again and tried it like a Carbon style. I tried to paste, I thought that only the face part is okay, but I tried various Seat sizes as well - - - Also bend the 2 mm wide part of the side (L) Folding (L) Even in the folded state of Fit it will be quite Fit, I am satisfied with the unexpected Fit feeling.
It looked good with black and unified feeling came out.