Attached to Kawasaki car which adopts KYB suspension - I exchanged.
Decal itself is somewhat short, so if you just paste it
Swingarm's 3 / It will be about 5 Cover.
If you cut the remainder of Seat and Cut it can be extended and pasted,
This makes Swingarm 3 / We can cover about 4.
It is a bit poverty, but because the purpose is protection,
There is no hand that does not use effectively.
To protect Fork, purchase for Dress-up.
Because Fork of the installation vehicle was somewhat narrow, I cut it and affixed the edge.
Because I hardly stick a sticker to the cylinder, I did it more carefully than usual. Of course, warm with degreasing & Dryer.
It's past five years since I pasted it, but I can not peel off at all (Lol)
It's not too expensive, it's a recommendation for protection.
I pasted it was a midwinter, so after I degreased the Swingarm cleanly, I firmly warmed both sides and pasted it with Dryer.
Just stick it with your fingers little by little to prevent air from entering.
Even after age, it is good without peeling or scratching.
Although I hesitated for a moment to make Tire other than Dunlop wear (Lol)