I used it with KawasakiZ1, Front double disk. Piston diameter is 5/8 If you use RiproManufacturer's z1 z2Master Cylinder, you can be assured that this Master Cylinder is the best. You can keep the OEM look without looking too flowery. This is for Handlebars with Sauce angles like the YBHandlebar.
If you're looking for a clip-on handlebar, this is it.
Suitable for Handlebar with lowered Grip end. The Lever touch is also perfect, and the subtle Release operation can be performed without a sense of tension. I felt it. Compared to the separate type, the tank capacity is about half, so it may not be suitable for endurance race. The performance is perfect.
I bought this product to replace the assembly because the brake fluid does not stop leaking even though I replaced the inner kit of the master cylinder. 14mm piston outer diameter, silver lever color, reservoir tank and cylinder integrated type were the requirements I was looking for. It is necessary to cut off the NORMAL connector and replace it with a flat female terminal to fit the 2 pole terminal of the stop lamp switch on the front brake. The design of this product fits well with the RetroMotorcycle.