I live in Canada and heated grip are not a luxury. It allows me to use my motorcycle a few additional months. These grips are great quality, easy to install and offers allot of heat settings to make my hands comfortable at any temperature. At first I thought there was to many levels and didn't think I'd use them, but I was wrong, on a cold morning just a few degrees are enough before the sun does the rest, chiliy afternoon a few degrees more... nice! In my opinion, these could is OEM quality.
[How is it used? I purchased and installed this product for use in Touring during the winter months. Was the one you received as per Image? The Grip diameter was almost the same as OEM. Was the installation difficult? The work itself is not difficult, but I had a hard time installing the Left SideGrip. I think it is influenced by the fact that I was working in the low outside temperature in the winter, but the Grip did not fit in the middle and I could not pull it out. Therefore, I installed the Grip while hitting it lightly with Rubber hammer. Because the Throttle part of the Right Side is an assembly, it was possible to exchange it without the problem afterwards as long as it was possible to remove and install the accelerator wire. How was your experience with it? I tried the most Large (Red) to see if it would get warm, but it did pretty quickly. By the way, because I think that the Winter Gloves which has a lining in the palm is difficult to transmit heat, I buy GK-839 of Komine and use it, but this Gloves has no lining in the palm, and I understand that heat is transmitted well. [Included Parts:were they on? Plate, Washer, etc. for gap adjustment [Was there anything that disappointed you? I feel that the speed to become warm is slow. The most Large (Red) felt that it would be better if the temperature rose a little faster. [Others] This Grip heater is the type that doesn't need to process Throttle pipe, so the installation work will be easier. Although the Instruction Manual is attached, because it becomes the installation Instruction Manual for the person who has some knowledge, the person who doesn't know how to loosen the Accelerator Wire and the person who doesn't know how to remove the Switch Box should ask the shop to install it. It is good.
"NC750X is directly installed, the length of 120 is just right, does not affect the installation of the hand guard, and it is perfectly matched. It is installed in the market for half an hour. After installation, the hand feels good and the temperature control is fine! At present, the temperature of Nanjing is 0 degrees, and the 2 to 3 gears are enough for use. - -------------------------------------------------- ------ NC750X is installed directly, 120 long, does not affect the handle installation, perfect cooperation, install the market for half an hour, after installation, the hand is good, the temperature control is detailed! At present, Nanjing 0 degree temperature, 2 to 3 gears are sufficient.
[How is it used? Commuting Was the one you received as per Image? Yes Was the installation difficult? There are three parts to choose from to attach the Accelerator Wire, but I wasn't sure which one to put on. The shape is the same as OEM, but the thickness is different. The thickness is the same and the shape is different. The installation itself is easy. How was your experience with it? Very good. It warms up well. [Included Parts:were they on? Yes. [Was there anything that disappointed you? None