Easy to remove as it leaves the center of the fin. I think that there are times when you may remove fine fins, such as cleaning Battery and replenishing cooling water - - -. Every time you do not have to remove the Slider, the fins get out with Sue. Last time, it seems that there was no real feeling with only attached pictures, so I will update again. I have not fallen yet, so the effect is - - - ?
I used OverRACING, but because it is hard to remove the SIDE fin, I replaced it with this product. Easy to remove as it leaves the center of the fin. Since the product of Over gets out from under one, it scratches and struggled to remove the fin. However, because it is above the product of Over, when I fell down, I felt that SIDE was scratching a lot and I installed the Engine slider at the same time. The result is still unknown.
Since it became hollow, it is in play [ the ].
マズ was unhurt except the Undercowl, it guards perfectly. the
SLIDER50 -- ガッツリ 削れました (smile) --
> -- and it slides very well. Although surprised, sliding to the opposite lane had little traffic, and it was saved (^-^;
Even if only that fails to get off the ground, it is a crack of only a Undercowl, and I think that it is the engine performance as expected.
since it does not understand unless it fails to get off the ground about the engine performance, it cannot say anything, and I do not want to meet with such a situation (^-^;
-- attached and considered is fairly good. It was said and begun to also feel a Logo mark, and since a price is also cheap, it is satisfied for the time being.
I was looking for a frame slider and I found a company called Babyface.. The zzr1400 I purchased this time is going to be installed in the 18 year model.. I have not installed it yet, but I have to buy a lot of reviews and ratings.. zzr1400 seems to be compatible from 12 years.. The order arrived in Korea in three days. I ordered it by standard EMS and it is fast..Good..