หน้าแรก

【KITACO】Reinforced Clutch Spring Set

    • ความพึงพอใจ:

To the hardness as expected

  • ผู้แสดงความคิดเห็น: Japan User(translated)
  • เผยแพร่เมื่อ: 2017-11-05 19:31:39
I am using it on GROM.
Though KITACO made is solid compared with Takegawa, three seems to be enough.
If it is still unsatisfactory, there are 6 pieces, but if you use 6 pieces with KITACO there is a possibility that the holding plate will be broken, so if you use 6 items, recommend purchasing a separately purchased reinforced holding plate.
Recommendation of three mounting positions to three places where Bolt is sewn.
Although it is impressions after use, although it did not proceed even if cutting halfway Clutch while stopping up until now, if you do not cut clich by inserting Reinforced Spring it is enough to advance forward.

ตอบกลับ

ลงทะเบียนเพื่อแสดงความคิดเห็น [ลงทะเบียนแบบสมบูรณ์]

ความคิดเห็นอื่น ๆ

Three in GROM think that it is enough. Funafuna Clutch lever becomes the feel of Clutch of motorcycle class and the connection is also connected. When half-club is coming halfway, the car body shakes and it tries to connect even now. Because there is a possibility that OEMCover will break if you put 6 pieces of this product, we recommend purchasing Cover separately. In case you have three, it is good to mount it in a position where Bolt exists.

6 pieces used
Oil does not come out from Case when changing when changing Oil
It becomes heavy but I forget to attach it in one week.
It gets better. Cost performance highest

While examining Custom, I learned about Clutch Spring and tried to replace it while exchanging Oil. For fe Ring, personally I thought Clutch would be heavier, but it was not that much.
As feeling it seems easy to accelerate with rotation... ?

I bought it about three months ago, but replaced it according to Oil exchange.
In addition, I exchanged Sprocket before and after and Oil pump.
I also recommended exchanging caskets, but I did not exchange it. Oil Leakage has not occurred.
I exchanged all six Spring. However, compared to Clutch of ZX - 14R, 1 in STD / Clutch can be cut with a power of about 10, so even if it is doubled it is judged that there is no problem and it is all replacement.
The power of Clutch cutting can not be increased as you expected.
It seems that Clutch meat seems to have gone up at launch. The replacement work was easier than I thought, but I did not see well when Spring was squeezed, so I was worried when fixing.
Netetc. I examined it, but a good photo etc.. I thought that it would be like this and assembled it.
Crying Motorcycle sideways, it seems no problem when working, but what do you think about entering insects in the work in the garden?.
I was able to assemble it without problems.
As Oil Filter garbage was pretty much attached, I cleaned up at the same time.
Even an amateur is recommended because it can be easily replaced if maintenance manual is available.

Clutch is too hard to put on all six
It became a good feeling as slipping disappeared if only 3 pieces were made
Installation was possible without Special Tools, Holder.