The OEMMirror on the ninja250 was very easy to read. It was ridiculed as Rabbit's ear or insect's antennae, and was replaced because of its bad parenthesis.
I had replaced it once, but the visibility was really bad. I have installed the included Spacer to lengthen it a bit.
Visibility directly behind. With the Housing portion of the Mirror turned inward the most, the Adjust it back and forth in the bracket so that the arm holding the Handlebar hangs slightly over it. If you move your arm out of the way, you can see directly behind you.
Also, the thin Pink Mirror is a Tension-enhancer to watch! I am satisfied with the Mirror shape and Parenthesis.
I had no problems at all using it on the highway!
Be careful not to tighten Bolt too hard or the Shield will crack.....................sweat
The base of the Mirror will loosen quickly, so it is recommended to apply a low-strength Screw lock agent to fix the Mirror in place after some positioning. [Color] It is a clear purple color and the inspector will decide if the car can or cannot pass inspection. I have been through more than 5 USER inspections and 3 times I was told "No". I recommend that you take the OEM Mirror with you when you go through the inspection, the purple Mirror surface makes the headlight from the car behind you at night less blinding. The rear visibility is still not as good as OEM. The price/effectiveness ratio is not so good. If you are going to buy it, you must like the look of this Mirror, or you may regret buying it.
It is similar to the atmosphere of OEM Mirror, so I think it blends in very well with the car body. The field of view is fine for checking diagonally behind. However, the Bracket to Mirror is a bit shorter than OEM, so it is harder to check directly behind. However, I like it because it has good design and texture, and I have no problem checking the diagonal back.
[How is it used? Not compatible but can fit wr155, so it is installed.
Was the one you received as per Image? PeLePeraFilter as per Image
Was the installation difficult? The base rubber is a little difficult to fit into the small size mold.
How was your experience with it? High speed is good.
[Included Parts:were they on? None in particular, Sticker available.
[Was there anything that disappointed you? Too bad the installation accuracy is not good enough.
Other items that would be helpful Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
I'm using the Non-seal and Seal chains interchangeably. I bought a Joint from Clip. I was wondering about the durability. The Joint section did not break and come off after 10,000 or 20,000 runs. With Crimp, once you Crimp, it stays in place until you replace the Sprocket. The Clip type is convenient because it can be replaced quickly.