The sales of this Rothmans color model was limited to 4000 units. It was sold in commemoration of the double victory of Freddie Spencer at the WGP (250cc & 500cc).
Because I bought it in the spring, I thought that I do not need Screen yet.
Running at this time seems to have quite a wind effect, so in this case I looked for something good, and OEM was so expensive that I purchased this item.
I will do Impression on my attention point in a little installation.
First of all Bracket has many scratches, someone was written. - - - - - It was launched to Webby
1. First of all Screen temporarily holds Bracket
2. Spread a little Bracket on the Fork side by hand (Inside I roll a Rubber) Is included
3. Position BracketBody by placing cloth on Clamp (R, L) - - - Mark 50 mm from the top
4. While aligning Screen with ForkBracket and Light, Quantity : Pair (for Left and Right) Apply the same height so that
5. We will further tighten up each part
6. Check the final confirmation and check if there is any fun place to complete
I watched it while running, but it seems like I got hit by the wind even a little Short.
Although the product is Short, I do not know if Long was good, but I thought the resistance was low.
Although I recommend you to "Yes", installation is quite a hard work, so it is to those who can prepare and install.
It is my first exchange since I got on a new car. I am amazed by NORMALPad with about 30,000 km. Because I attached Red Pad with a different Motorcycle, I decided without comparing with others in particular. I feel that NORMAL's Rotor is bad, but it seems to be bad, but the credibility is better than NORMAL. I do not know Cost performance yet
I have not tried Plug replacement, etc. until now, it will be a perfect foster age and, on the contrary, I want to do various things by myself Today is around this time. I hope changing it after all. I feel good with a single shot start. My attachment also comes to Motorcycle more. When you do it, whatever you face is white Do not you think?. Correct Brand is the correct answer.
I installed it in REBEL 250. I bought Smoke's Long. Below
<About Fork MountingBracket>
It was full of scratches from the beginning why. It is unknown whether it is what was attached before shipment or what was attached after shipment, but it was full of scratches anyhow.
The machining accuracy itself is good, and it fits Exactly to the Inner Fork of REBEL. However, installation is a bit painful.. Bolt and Bolt holes are difficult to match very closely.
<About Screen and Bracket>
Bracket mounting holes (Hole through which Bolt passes) Because it is located on the surface of Screen. When stopping Bracket with Bolt, I'm puzzled as "various". But by never tightening Bolt tightly you can install. (Manufacturer confirmed)
<Impressions of installing and running>
The wind beneath the nose is obviously relieved. That's why the wind above the nose got stronger. Therefore, when using the Helmet with high rectifying effect, there was nothing wrong, but when using a combination of ordinary Jet helmet + Bubble shield Shield was unpleasant to shake strangely.
It is attached to REBEL 250.
It was really simple and clumsy I could install it in 15 minutes ~ 20 minutes.
It is much more compact than looking at images. Weight is also much lighter than OEM.
It becomes one turn heavy bass compared to OEM, Idling sound etc etc at the same time. Also increased by one round.
Perhaps it's a quiet residential area.
<Impression that I tried running>
The slow Torque is a thinned impression. To that extent, turning "Dappapapat" And I will accelerate well. When you turn the OEMExhaust System "Bean" A little lonely sound like feeling (Something that sounds difficult) It sounds, but this Exhaust System does not have it.
<Whether to buy or not>
decidedly "buy" is not it.