HONDA HAWKIII CB400N
It adopted a design that inherited the impression of the CB900F, which was the top sportbike model of HONDA at that time. It had the engine and the body of the HAWKII.
Off Car Exterior Replace with Cowl's H4 Bulb.
Off There is almost no Space behind Light if there is a car, buying this product because the fan on the Connector side does not fit well.
When I looked at the LED from the front, I was worried that the light would go forward ahead, but it was dazzling when I saw it from the front after installation.
Although it was said that the head was not rigidly attached by the other person's review, it was able to be installed without problems.
It is unknown how bright it is because I do not run at night, but I am expecting Large as I was not flickering at Idling like Mr. Halogen.
And how long is the life span.
In the case of the SR 400 OEM's Reserve tank integrated Master cylinder, Parts itself will inevitably become Large, so Handlebar replacement etc etc. , Custom around the Handlebar may interfere with fine adjustment of the positional relationship of each part. As this product is separate from the Reserve tank, compared with OEM, the degree of freedom of the installation position is high, it is a nice point for the Custom faction.
By the way, Brake's Fing Ring itself changes obviously compared to OEM.
OEM 's Master cylinder is early Touch, the rise of braking is relatively strong and it is clearly clear, there is no change in braking force which is too large even if gradually grasping from there, a certain pressure is applied Wherever, it was Fei Ring that seemed to work strongly, but I did not like it much.
On the other hand, this product often says "Linear" It is effective. The braking force rises to Smooth by the grasping amount. I think that the diameter of Master cylinder may be different from OEM, but obviously the controllability has improved.
Of course, I think that adjustment can be done by characteristics of Brake line and Pad, so it is only comparison with Master cylinder.
Also, the Lever position adjustment mechanism of the Dial formula, which is not found in the OEM, was delightful. It can be adjusted in a moment without tools.
Wiring processing of Brake switch is necessary, but it is not so difficult task, so if you are familiar with terminal processing work, Wiring processing will end within 5 minutes.