Please login to check coupons
Product Detail
Specification
[Material]Aluminum Alloy Gold[Weight] 201g
[Dimensions] 96.5x51.5x57mm
5V 2A
Universal joint X1
U-Bolt X1
Wrench X1
Hexagonal Wrench X1
Large Spacer X1
Small TypeSpacer X1
Rubber Pad X2
WasherQuantity:Pair X2
ThumscrewWrench X1
3P Long-1/4InchAdapter X1
Non-slip Ring X4
Caution
1. Based on the clamp position and size, install the spacers inside the U-bolts.2. Before use, tighten the universal joint firmly onto the U-bolt.
3. The supplied washer pair consists of two spacers. Be careful not to lose the spacer set when disassembling the unit, as the nuts may loosen due to vibration if the spacer set is lost.
4. The U-bolts can be mounted in a secure location on the bike frame, rear pedal bracket, bumper, etc. Make sure that the U-bolts are locked in place and that there is no rotation or play in the mount when secured.
5. Driving is only recommended on smooth roads at speeds not exceeding 80 km/h. Off-road driving is not supported.
6. To secure the Insta360 invisible action selfie stick, it is recommended to connect it with a 1/4" adapter with universal joint. Do not connect the selfie stick to other accessories. The universal joint may be damaged.
7. If the motorcycle is to be parked outdoors for an extended period of time, remove accessories to keep it in top condition.
8. Use the accessories according to the installation instructions in this manual. Damage caused by failure to follow the instructions is not covered by Insta360's warranty or replacement service.
9. When using the GO 2 in action scenes, be sure to use the Action Mount Adapter.
*Please note that the product specification may change due to manufacturer reasons.
*It may included other products on the photo.
Review
0.0
/ 5
(0 Review)