Engine Kit With Cell-Starter 124cc With All Kit
- Product number: ca1656
- TANAKA TRADING
- |
- 0.0
- (0 Review)
Please login to check coupons
Product Detail
Specification
[body color]・Silver
[Specification]
・Displacement: 124cc
・Manual clutch 4-speed (shift pattern 1-N-2-3-4)
・With cell-starter
[Components (for MONKEY)]
・Kick Pedal
・Shift pedal
・Carburetor (Φ22)
・Manifold
Oil cooler
・Oil catch tank
・Rear sprocket (29T)
・Throttle holder
・Left / Right switch
・Right and left grips
・Clutch wire
・Throttle wire
・CDI
・Regulators
・Blinker relay
・Starter relay
・Ignition coil
・Main harness
Description
Attached harnesses: For Monkey
Note
* The image is only for reference. The image shown may differ from the actual product.
Caution
*The attached manifold is for the carburetor sold by Tanaka Trading [ca30, ca31].It cannot be used with stock carburetor.*The included manifold sprocket is for Monkey.Some vehicles (CHALY, CUB, etc.) may require modification and may not fit.
*For 12v vehicles, the stock harness can be used, but the coupler for the engine connection must be replaced with a crimp terminal.
*When installing on a 6V Vehicle, the [ca885] 12V engine replacement harness is very convenient.(The 6v stock harness can be used, so there is no need to change the harness)
*When installing on a 6V bike, it is necessary to convert the electrical system such as battery and valve to 12V.
*When you install it on CHALY, you need to cut the interfering part because it interferes with the frame.
*Since the included switches cannot be used with the coupler on the Cub's harness, wiring modification is required.
*Regardless of the harness selection, the set contents are parts for Monkey.
*Tanaka Trading does not exchange products after shipment.Please check the engine model carefully before purchasing.
*If the breather pipe of the engine body is installed between frames, the pressure inside the crankcase will increase and oil will leak out, which is very dangerous.Check the condition of the breather pipe after engine installation before starting the engine.
*As this is a set product combined with the accompanying harness, wiring modifications may be necessary.
*The sprocket attached to the engine is for checking the engine start.Sprockets are not replaced.
*There may be changes in product specifications due to the manufacturer's reasons.
Model Page Links
Review
0.0
/ 5
(0 Review)