Please login to check coupons
Product Detail
Specification
[Material]Lock nut: Made of plastic
[Included]
1. Camera body
2. Rear cap (Strap can be attached)
3. Holder for fixing the main unit
4. Bracket
5. O-ring (for waterproof caps)
6. Grease
7. Screw (1/4-20 x 3/8)
8.3M dual lock fastener
9. USB cable 1.2m with waterproof cap (for main body connection)
10. strap
Description
The camera can be adjusted and fixed in various angles.
In addition, included is a base that can be used for curved parts such as helmets and cowls.
In addition, included is a base that can be used for curved parts such as helmets and cowls.
Caution
*When this product is mounted on the helmet, do not connect the power supply from the vehicle while driving.*This product is only for our Multi Drive Recorder.Please note that Endurance not confirmed the installation of the product.
*When this product is attached to the helmet, please do not carry the helmet with this product.This product may be damaged and the helmet may fall off.
*When placing the helmet with this product installed, please be careful not to give any impact to this product.
*Do not use the USB cable while driving if it is installed on a vehicle other than the vehicle.
*Do not over-tighten the lock nut of the pedestal support because it is made of plastic.
*In some cases, double-sided tape may be used to install this product, but the perfect adhesion with double-sided tape cannot be achieved, so please check the product periodically and reapply if there are any problems.
*When double-sided tape is used to install this product, the adhesive strength is so strong that it may damage the adhesive surface or leave adhesive residue when it is removed.
*Please read the instruction manual for details.
*The microSD card is not included.
Applicable Models
Universal
Review
0.0
/ 5
(0 Review)
