Material: steel [Size] Lock bar diameter (U-shaped part): 16mm (diameter is about 20mm including rubber coating) Internal width of lock bar (U-shape part): 128mm Internal height of lock bar (U-shaped part): 210mm Built-in alarm unit diameter: 34mm (Silicon cover is not included.) Built-in alarm unit width: 194mm (Silicon cover is not included.)
[Set components] ・Special tools ・Key ・CR2 lithium battery ・Back of the package / Instruction manual (English)
Description
This is a very strong U-shaped lock with a strong steel body and a strong key barrel. It can be tightly fixed to tires and wheels. The diameter of the lock bar is 16mm, which makes the lock stronger. Also, the internal width of the lock bar is large enough to accommodate larger tires. Of course, it can be used not only for motorcycles but also for bicycles. When vibration is detected, a piercing alarm sounding at a loud volume of 120dB is emitted, and this product is effective in preventing theft of your vehicle. In addition to waterproof specifications, the body of the disc lock is finished with a special surface treatment to give it a high-class look. The battery for alarm is CR2 lithium battery.(It can be used for approx. 10 months) In addition, the alarm has an [ON / OFF] function.
--- Operation --- [How to switch ON / OFF] When the key is turned (approx. 270°) to lock and then turned back, a short "beep" sound will be heard once, followed a few seconds later by a notification sound indicating that the security alarm has entered the ON mode. By repeating the same operation quickly again after turning on the device, you will hear a short "beep" sound twice.In this case, the security alarm is turned off. *When you lock the key, please confirm the sound of operation and lock the door.
[How to install the battery] *A Phillips screwdriver is required in addition to the supplied tools.Please be prepared. 1. Remove the lock bar. 2. Insert a Phillips screwdriver into the hole of the lock bar and remove the screw. *Remove the screw from the side without the key cylinder. 3. Remove the silicone cover, cover, and alarm unit in that order. 4. Remove the two screws from the alarm unit with the supplied tool. 5. Remove the battery cover and waterproof cover and install the battery. 6. Assemble in reverse order to complete. *Please be careful not to forget to attach the waterproof cover when you install the battery. *When installing the alarm unit, be careful to insert it into the notch on the alarm unit.
Caution
*Please check the tire size of your motorcycle. *There is a slight dimensional error in the size description.
