Please login to check coupons
Product Detail
Specification
This product is used when you want to remove the stock O2 sensor from the exhaust when the O2 repressor is installed.This is a set of special blind couplers and special bolts / aluminum gaskets to seal the holes in the exhaust.
Description
When the O2 sensor is removed from the vehicle body by disconnecting the coupler, use this blind coupler to cover the body side of the removed coupler to prevent dust and rainwater from entering
Prevents accidental problems.
The blind coupler prevents the ECU from detecting that the heater has been removed.
Also, use the special bolt (with aluminum packing) to fill the sensor hole in the exhaust.
Prevents accidental problems.
The blind coupler prevents the ECU from detecting that the heater has been removed.
Also, use the special bolt (with aluminum packing) to fill the sensor hole in the exhaust.
Caution
*This part is designed to be used with the O2 Releaser.*Not available for early Taiwanese FI models (without TPS sensor) and Japanese models (without O2 sensor)
*Not available for November 2015 release (rear wheel disc brake specification EBJ-SEA5J / E3T5E)
*If you use only the blind coupler set without the O2 releaser, the O2 sensor signal will not be input to the ECU at all,
Depending on the condition of the engine or the way of operation, the air-fuel ratio will always change, and various symptoms such as increased idling and poor blowdown will occur.Depending on the situation, the FI light may come on.