Reviews
KaEdia is still good!
Although many companies have released SMARTMonitor, I have been waiting for CaEdia's product. I have been waiting for a product from CaEdia because, after all, it is the most cost-effective. I have purchased many of KaEdia's products and knew their high quality and high cost performance, so I had no hesitation in deciding that the SMARTMonitor would also be made by KaEdia. After more than two months of ordering, the SMARTMonitor finally arrived.
There was a small product defect there. It was a paint bald on the housing.
I immediately contacted KaEdia and they were able to promptly replace the item with a good one. As expected of JapanBrand ^ ^.
After installing it, the actual feeling on the Motorcycle is perfect!
View detail
No worry about falling off.
There is no sign at all that the 120km/h section of the New Tokyo-Nagoya, the Decoration bumpy road, or anywhere else you might fall off.
Vibration absorption capacity is also very high.
I have tried a few and they are by far the most secure in preventing drops, and if you are really worried, you can easily lock it with Lever.
It is very easy to use as it is easy to connect Charger.
The only complaint I have is that it is difficult to clean because dust tends to accumulate in the groove where it is fitted.
Also, some people have a problem with the way it looks. (Depending on Motorcycle) It may seem a bit lumpy.
View detail
It is quite good.
Although it takes 60 seconds to establish the connection due to the Radio Law, this product uses a soft power supply that shuts down 5 seconds after the ACC power is disconnected, so even if your car model shuts down the ACC power at the time of cell start, as seen in BMW etc., the power will not be turned off when the engine starts. Therefore, if you put on the Helmet and Gloves after turning on the key first, you will be connected to your smartphone by the time you step over and turn on the Cell, and you will not feel the stress of waiting for the connection.
If your vehicle is equipped with a 12~16mm GPS Mount Bracket, the Tanax AIO-5 Mounting Bracket can be used without modification.
The cost performance is great, but the screen size of 4.5-inches is a little insufficient.
View detail
Easy to use
[How is it used?
I chose to install a new Smartphone Holder on my TouringMotorcycle and ultimately ended up with this product.
Anything as long as it's cheap!" I am very happy to be able to do this, And not too much of Plastic's cheap stuff, either." For me, I'm a bit of an either/or kind of guy. That's it! It seemed like a good idea.
Also, my phone has many buttons on the Right side, so I could not use the type that is inserted from the side, so I chose the type that is fixed at the four corners.
Was the one you received as per Image?
I chose Black and it was just like the Image.
How was your experience with it?
First of all, the Included Parts:are substantial for the price.
There is a diameter conversion rubberretc.Pattern and it is not difficult to install.
When the middle Button is pressed, the four corners are Fit to the phone.
Release is Quantity:Pair (for Left and Right) The only thing you need to do is to press the "+" and "-" prongs, so everything can be done with one hand while doing Gloves, which is easy.
[Points to note]
Make sure it is firmly secured before starting.
How did it compare to other products?
I had been using Chinese several hundred yen ones, but I felt they were well thought out with good strength and ease of use.
【Review】
I used to think that KaEdia was cheap or bad, but when I bought it this time, I got a good impression of Included Parts:, usability, etc.
As a smartphone mount, I have no complaints.
View detail
Easy.
Large is just right.
I change equipment from time to time, and it is useful because I can exchange it easily.
View detail
Touch screen is slow to respond. Instruction Manual is too easy.
The instruction manual only describes it roughly, so you have to learn how to use it by hand. Except for disassembling the bike, wiring is not difficult with color-coded connectors. However, since the connectors for the front and rear cameras are the same color, it is recommended to temporarily turn on the power in the middle of the installation (since the rear camera has a reversing function). If you are concerned about the dark current, the instructions say to connect both ACC and constant power to ACC, but I connected ACC and constant separately because I was concerned about the inability to use the parking monitoring function and the time gap. If you use your motorcycle infrequently and are concerned about battery drain, it is better to use only the ACC connection for constant and ACC. As mentioned in the title, the response of the touch screen is sluggish. It is frustrating with gloves on. There is no automatic screen illumination adjustment (I always use max except at night). The smartphone app is supposed to be able to connect to the driver's recorder, but I don't know the password, so I still can't use it. The home button on the map screen is annoying. View detail
Depends on the use of Main.
I purchased Mirror as Main, which is easy to see during the day.
I bought this one considering the cosmetics including Included Parts:because it was difficult to see the screen in Situation where the sun shines during the daytime with my previous driver's recorder with Monitor.
The screen visibility is not as good as the Tanax SMARTRideMonitor installed on Main's Motorcycle, but if you don't compare it to the Tanax SMARTRideMonitor, you can see the screen even in daylight at a perfectly acceptable level.
In terms of the total price including the Air Pressure Monitor, I think it is a totally reasonable price.
I use it in car play, but when I want to use it in Camera screen, it tries to switch to car play by itself, so I have to operate it each time to switch the screen back.
I would appreciate it if this is fixed in a future version up, but I have no problem using it as a SMARTMonitor.
But overall satisfaction is very good.
If you are hesitant about Tanax because of the price, I totally recommend it. Quantity with the same content:Set is almost half the price, lol.
View detail
Difficult to understand the settings
It does not include a detailed instruction manual, which is a problem when it is not connected to a smartphone.
I set it up while emailing Manufacturer.
Since the Instruction Manual is the same as the Instruction Manual that comes with the DriveRecorder, it is difficult to understand whether it is not displayed due to a defect or whether it was not displayed in the first place.
View detail
Solid, compact, and unobtrusive around the handlebar
The SMARTMonitor has a growing selection, but the KaEdia KDR-D21 is characterized by its compactness, versatility, and high quality. 4.5-inches screen is smaller than a Smartphone, but it is recommended for those who want to refresh the handlebar area. The 4.5-inches screen is smaller than that of a Smartphone.
Installation is easy
Simply connect the power supply (Red and Black) to the Battery and the Attachment power supply (Yellow color).
All that remains is to connect the front and rear Camera and GPS to the Body (Monitor) to complete the SMARTMonitor equipped with a driverless camera.
There are four cords coming out of the Body, but they are soft and not difficult to maneuver.
The connection to CarPlay seems a bit slower than other models, but so far there seems to be no concern about disconnection after a long drive. Also, there is no such thing as losing direction when turning such as UTurn so far.
Since recent CarPlay includes meeting tools such as Teams and Zoom, it may be possible to do things like Touring while talking with multiple people instead of Income connection.
DriveRecorder is generally called highly functional, with beautiful images, and by using the KaEdia application, you can obtain sufficient information even with a Smartphone.
The app is stable in normal use, but in my environment (iPhone) the app crashes when setting up Camera. I hope this will improve in the future.
I have a Handlebar Brace (KDR-HB2) on my CB200X, so I put SMARTMonitor on it.
The company is also a well-known manufacturer of Smartphone Holders, so the product comes standard with an anti-vibration function and seems to have no durability issues.
This was my first experience with the Tire Air Pressure Check, but I was able to Pair it by removing the Pairing on the DeFault and re-installing it again. If it does not work, you may want to remove it from the Valve and reattach it again.
SDCard is not included, so it is recommended that you obtain the necessary Size's first.
Tests before connection can also be performed by feeding power to the USB-CConnector located next to the SDSlot.
(I know it's hard to use USBConnector when it's on-board)
Overall, the quality is good and the features are adequate for the price.SMARTMonitorQuantity recommended for those who are looking for a Compact screen.:Set
View detail
Easy to use
It is a replacement for DAYTONA's Smartphone Holder.
It is easy to install and easy to use.
Vibration absorbing Bumper was installed at the same time.
View detail
Effects not known.
I installed it to prevent my phone from malfunctioning.
The installation itself is easy, but so far the effect is unknown.
It would be nice to have three different hardnesses.
View detail
Excellent workability
Best quality as Smartphone Holder. A product with no complaints in terms of retention, security, and workability. View detail
Better than the previous MODEL.
Purchased due to Motorcycle expansion.
It felt more solid (sturdy) than the previous MODEL.
Smartphone is also securely fixed, so you may not need Rubber's Belt?
Don't worry, even an amateur can install it easily.
View detail
Large texture
Size-wise, it's like a Large tree, but I think Hold is a good idea.
Good for single cylinder motorcycle as I also added vibration protection.
View detail
Smartphone Holder is the best!
The fit is so good that you don't feel the anxiety of saying your phone is going to fall off. View detail
Easy to use
It is convenient to attach a phone with One-touch. View detail
KaEdia SafetyBand
The band was shredded after about a year of use. I thought it would be better to make the rubber a little thicker or a little softer. View detail
KaEdia SafetyBand
I had to repurchase it because it shredded when I was stretching it to install my phone on a cold day.
It would be better if it were a little thicker.
View detail
Highest & High
The product was satisfactory for the Large change, as was the reputation. View detail
Used in combination with KDR-M14C
It is used in combination with KDR-M14C.
I use it on a road motorcycle, but since it is not for motorcycles, it may not be very effective.
There is no high frequency vibration like Motorcycle, so it may not have been worth it. I bought it for comfort.
View detail