Reviews
Fits: YAMAHA , KAWASAKI , YAMAHA MT-07
Used in LED Blinker replacement
To be honest, any similar product would be fine, but since we replaced it with D-Light ONE by DAYTONA, we matched it with D-Light ONE made by DAYTONA just in case. View detail
Fits: YAMAHA , KAWASAKI , YAMAHA MT-07
Installed on XSR155.
I purchased this product to install DAYTONA high sider ApolloClassic.
Nothing is wrong.
I think the quality is high.
However, the thickness of the external Fender Eliminator was too thin, so I insured it with Only rear.inHemp palmock.
It is not a problem with BlinkerHolder but a bad external Fender Eliminator.
I felt it was a little expensive in terms of cosmetics, so I gave it -1 star.
View detail
Fits: YAMAHA , KAWASAKI , YAMAHA MT-07
To replace Blinker
This is required for Blinker replacement in the Yamaha system.
Mounting Hole Size:Φ8, so it fits M8 Blinker.
View detail
Fits: YAMAHA , KAWASAKI , YAMAHA MT-07
FBlinkerfor Replacement of MT-09SP
Because the Front blinker of New ModelMT-09SP frequently comes off in pieces, and in order to fit it again, if the Cover is not removed and it does not do, it is considerably Large strange, in order to exchange it for the Small Blinker of Mr. DAYTONA, I thought that the same Manufacturer would be safe and purchased it. I did.
I'm very happy with the look and feel of the product, but I think it's a bit expensive…
I actually installed the OEMBlinker, but when I removed the whole OEMBlinker, it was too small as shown in image 2, and I had to reuse the Rubber frame that was inserted into the OEMBlinker. If I remove the whole OEMBlinker, it is not enough.
However, because the Rubber frame is crushed when it tightens too much because the Rubber is sandwiched, I tightened it with the degree of there, but because the Blinker which I installed is for the pole Small, or because the Nut of Reverse side is sweet like the image 3, it may come loose by the vibration when running. It may loosen by the vibration when driving.
I don't think it will fall because it's connected by Wiring, but if it comes off, I have to think of another countermeasure.
View detail
Fits: YAMAHA , KAWASAKI , YAMAHA MT-07
Blind.
It is purchased as a blind plug along with the relocation of MT-09SP to the Front Blinker.
I used ZETA's nifty Taper bolts to make the holes less noticeable.
I know it's a bit expensive, but...
View detail
Fits: YAMAHA , KAWASAKI , YAMAHA MT-07
no problem
I used it on my XSR900 with a Daytona Bronx installation and it's very accurate and the paint job is beautiful. No problem at all. The torque-tightening torque is weak in 10 Newtons. View detail
Fits: YAMAHA , KAWASAKI , YAMAHA MT-07
Items for installing the Blinker
In my case, Large size is too small for this type Because I have the Fender Eliminator Kit of Shinkai, I have to use the OEM Fender Eliminator Kit In the Kawasaki Size, it was small, but I was able to fix Blinker These are items to be attached between the two pieces of the bracket View detail
Fits: YAMAHA , KAWASAKI , YAMAHA MT-07
Satisfied
I bought this along with the purchase of a sequential blinker from DAYTONA
The installation accuracy is good and I'm happy with the results
View detail