Reviews
For Forest Road Touring
I bought it to not do off-road driving.
I am happy to buy it at a low price.
View detail
FOR JAPAN MODELManufacturer thinks it's better than what they are using
With the Bead stopper, I don't like the up and down vibrations, I don't use it for Race and Tire I removed the bead stopper because it didn't run with the air pressure down, so I installed it View detail
well settled
It was Exactly for the CRM, although the note said it wouldn't fit the Honda car, but it was Exactly for the CRM I like that it doesn't pop out like the OEM's Rubber Bush View detail
Peace of mind at a reasonable price
It is used on the 750RS rear wheel
I had a lot of trouble getting it on
This product provides a sense of security after installation
It has considerable promise against aging
The size of the hole may vary depending on the car model
Be careful when purchasing
View detail
A must-have for Mousse installations
When the Mousse was installed, the original Valve installation part of the Wheel was naturally drilled When you drive it, a lot of mud and sand will come in from there It takes a little bit of force to insert it, but if you apply Silicon spray, it will be easier to insert It will be easier to get into the car if you spray it with Silicon spray etc View detail
Installation is fairly solid
I closed the hole of SEROW 225 WOEMWheel. Because the installation is rather hard, Greaseetc. I had to insert it with a handle of the Driver and it did not enter..
It is hard to come off as it is tight.
View detail
Good stuff
When I switched to OffWheel, the hole of the Bead stopper is Quantity : 2pc. There is one set of which one was attached to Cap, but it was not in one more location so purchase. Probably bead setting please attach. Quantity before and after : 2pc. Set I asked for it because it was not enough. This is enough as I will not run until I lowered the air pressure. It is cospa good. View detail
Can I use it for Honda cars? No problem with M8
I am using it to close the hole of the Bead stopper once opened.
In item description "Can not be used for Honda cars" There is, but since the hole in the usual Bead stopper is M8, it feels like it will not change. In Honda's car model there is a case of a hole with a large diameter, is not it? Tube is like unity, I think that it can be used without trouble if measured with Vernier calipers by 8 mm.
Although it puts it from the inside, the diameter itself of the Rubber part is about 10 mm and it will be used to push it in. Although it is quite difficult to put in, I feel secure when I put it in well.
View detail