Reviews
Shift up stand for monkey - very handy
I had these on my honda monkey minitrail. Very handy for lubricating your chain or removing your wheel. I am definitely going to buy these again for my other z50j6 View detail
It is difficult to adjust the flip angle.
I attached it to NORMAL's 12 V MONKEY.
Maintenance became easier, such as Chain adjustment.
However, adjustment of flip angle is troublesome.
In my case, the Stand Assist bar was in contact with the road when Left folded, so I cut it a little with a Gold saw.
Also, since it interferes with Spring of Side Stand, we try not to use Side Stand as much as possible.
View detail
Center Stand is necessary for any Motorcycle.
I mounted SHIFT UP Center Stand in JAZZ.
Because I replaced Rear suspension with DAYTONA 's AluminumShock 240 mm Meter, the car height rose and I had to cut it apart, but the serviceability has improved very much.
There is no loss by wearing parts.
View detail
It attached to the GORILLA of the Swing-arm specification of a 4-cm Long. Although 4T Aluminum Collar was attached to the interference adjustment with the Chain etc., it fell, when there was no Aluminum Collar of case, it interfered and put into
It attached to the GORILLA of the Swing-arm specification of a 4-cm Long.
Although 4T Aluminum Collar was attached to the interference adjustment with the
Chain etc., it fell, when there was no Aluminum Collar of
case, it interfered and put into the Chain and it had bounded, and it became feeling
, and not a color but the flat washer adjusted as a result. [ of my vehicles ]
If there is no Maintenance stands,
attachment is too low-slung, and may be trouble.
Although it is the
using feeling, if it is used, a car body will incline to the right merely slightly.
Although
which comes from manufacture cannot be concluded, it is a little worried.
However, in the case of a Maintenance, if there is a Center stand too, convenient thing
is realizable.
View detail
Although there is no room to waver if it is attached since the center stand which can be attached with the monkey has only this ... Somewhat thinly, the stand also had the attachment to a car body considered considering a price to a slight degree, and ext
Although there is no room to waver if it is attached since the center stand which can be attached with the monkey has only this ... Somewhat thinly, the stand also had the attachment to a car body considered considering a price to a slight degree, and extorted it from it.
It is whether the result of a cub, or a moped and that original manufacturer's product is better.
A center stand is touch with a balance, the sufficient middle maintenance of a car body in the one more needed, etc.
Since fixing the stand changes into an accessory the bolt of the two backside which is fixing the step and it only attaches it, the reinforcement as fixed power and a stand with a car body has uneasiness a little.
Refer to the 812.com for attachment.
View detail
When there is a center stand, it is messy convenience at the time of maintenance. Attachment was troublesome.
When there is a center stand, it is messy convenience at the time of maintenance.
Attachment was troublesome.
View detail