- Home
- Product reviews
- Search reviews
Reviews
Fits: YAMAHA Super Jog ZR, YAMAHA SUPER JOGZ, YAMAHA AXIS 90, YAMAHA JOG (2Cycle), YAMAHA JOG (2Cycle), YAMAHA JOG (2Cycle), YAMAHA JOG90
4JPAPRIO is now attached.
The Center Stand for 4JPAPRIO that was given to me was wobbly, so I bought it FOR REPLACEMENT.
Webike's site does not list it as an applicable model, but KN Kikaku's site lists it as an applicable model.
4JP does not guarantee the suitability of Webike, so you are on your own, and if you have any questions, you should contact KN Planning directly.
I have no particular problem using it.
Installation requires a bit of hang, but you can find a lot of information if you search.
In my case, I had a separate Side Stand, so I worked standing on the Side Stand, but for those who only have the Center Stand, I think it is better to work by standing it on the wall etc. while protecting it from damage.
However, it is difficult to work from the Left if it is standing up.
When removing the spring, it is easy to make it move easily with CRCetc., pull out the pin with radio pliers, put the Penetrating Driver on the shaft, tap the shaft lightly with a hammer, pull out the shaft, and finally remove the spring.
(Be careful not to interfere with the Rear Brake Wire and Shaft.)
If two people can work on it, it would be easier to install the spring first, then put the pin through the spring from the left side, one person should hold the right end of the stand and align it while extending the spring, and the other person should apply the penetrating driver from the left side and tap the spring lightly with a hammer. The other person should hold the Penetrating Driver from the Left and tap it lightly with the Hammer.
Since it is not possible for one person to do this, you need to install the STAND first, hook the spring to the body side, put the other side through a long slotted screwdriver, put the tip of the screwdriver near the base of the spring attachment part on the STAND side, and slide the spring while stretching it using the lever principle. Then, using the lever principle, slide the driver near the base of the spring on the STAND side, and hook the spring.
I used the OEM spring only because the notch where the spring hooks was narrower than the OEM spring and it was difficult to install. Therefore, I gave it 4 stars.
View detail
Fits: YAMAHA Super Jog ZR, YAMAHA SUPER JOGZ, YAMAHA AXIS 90, YAMAHA JOG (2Cycle), YAMAHA JOG (2Cycle), YAMAHA JOG (2Cycle), YAMAHA JOG90
Center Stand
Great service. Fits Jog 50 3KY 1994-1998. Same OEM. Perfect! Thank you staff WEBIKE.TH :D View detail