Reviews
Seems strong for the price.
If the MONKEY has 12inch wheel, 330mmRear suspension, and the Swing Arm is about 20cmLong, it should be about 260m. It is a little too far down, so it is just right to adjust the rest by using a collar.
It's STAND, so even if it's cheap, it's good enough because it's something that will get scratched whether it's of poor quality or not.
View detail
It may take some modifications to install
Originally, the NS-1's were diverted, but I changed the rear suspension from 380mm to 400mm I bought a 260mm one because of this, and it was helpful to have a longer one
However, because of the BALI in the mounting area, it didn't lock when I took out the STAND
I was about to fall over when I lightly pushed the car forward, so I had to align the front side of the mounting area with BALI and 1 i shaved about 1.5mm
It was only a light process, so well, it's inexpensive and it's a good price
The rest of the time, I guess you have to be careful with your hands because of the scraps sticking to it
View detail
It is a little thinner than the Honda APE OEM
What made you decide to buy?
Longer STAND is needed due to the change in suspension You can choose from many different length sizes and the best part is that the price is cheap
How was your experience with it?
I don't know about the durability of this bike, but the welding is very good I could improve the inclination of the motorcycle
Was it difficult to install? (In the case of hard parts)
The spring length needs to be adjusted after the replacement Because the hook part of the spring that comes with the spring was set long, I adjusted the hook part and installed it
What is the point or hang of installation (for hard parts)? I think it's easier to hang Spring when STAND is up Pulling Hooketc. tools is cheaper to install
[Was there anything that disappointed you? None
Do you have any wishes or improvements you would like to make for the Manufacturer?
We ask you to continue to provide products that other manufacturers cannot cover in the future
[Do you have any products to compare it to? None
[Others] None
View detail
Mounting on Grom
Swingarm exchange (25 mm Long + DAYTONA suspension) After that, I tried installing this product instead of Standard STAND shortened. Body does not work, but with Grom Standard, Screw Mountain is opposite and the orientation of Bolt nut is reversed, so we removed the Sensor. Also, because it comes in contact with Swingarm's Stubby at the time of storage, it is under consideration of processing. Because I used the original Bolt kind, I did not use the attached Bolt.
I chose 235 mm for measurement, but I also feel a bit too standing. I have not tried running yet, but since the part to be installed on the ground is Large, it's a leg (?) Is easier to raise and lower than the StandardSTAND that is in the middle. quality - I think the texture is the same as StandardSTAND.
View detail