- Home
- Product reviews
- Search reviews
Reviews
Used to reduce rattling of Brake lever
[How is it used?
Brake lever was rattling badly and I bought it in hopes that it would get better.
The Touch feeling of the MASTER itself was not so good, but I suspected that maybe it was because the rattling was so bad that I could not press the Piston straight? I also suspected that it might be because I could not press the Piston straight.
To be honest, since it is a SmallEngine Displacement Volume for a foreign car, I thought that the rattling might be terrible combined with poor accuracy, but I tried it when I learned from an article on Webig that this Washer can reduce the rattling.
Was the one you received as per Image?
As you can see in the picture, it is just a Washer.
It is not a very expensive product, but the price of this thin Washer may be too expensive for some people...
Was the installation difficult?
Simply remove the Brake lever and insert it in between.
Washer is just on Lever, so it is a bit frustrating to have to Gap it back to MASTER.
How was your experience with it?
Actually, I first tried 0.3mm, but did not feel much change. 0.6mm with 2 layers of 0.3mm reduced rattling in a good way. However, I felt that the movement of Lever was a little reluctant or stuck, perhaps due to the two layers of 0.3mm, and I felt it was dangerous.:I settled on 1pc. Even with 0.5mm, there is some rattling, but it has been reduced to an acceptable level.
However, I did not see any large change in the touch feeling that I had expected, and I felt again that in such a case, I had no choice but to replace the entire MASTER.
[Included Parts:were they on?
Washer only.
[Was there anything that disappointed you?
nothing special
View detail
I'm trying to get Lever to stop rattling!
[How is it used?
We are playing Enduro with Off-road motorcycle.
I was looking for something like a Shim for my Clutch lever, and I found this product. And I bought it.
Was the one you received as per Image?
As per Image
Was the installation difficult?
Remove the Pivot and after cleaning, apply a thin coat of Grease and insert the Shim here and you're good to go.
How was your experience with it?
The lever that was moving up and down stopped moving and became able to cut smoothly.
I'm happy with the Large variant because of the way I run and play with the Clutch a lot.
[Included Parts:were they on?
Not particularly
[Was there anything that disappointed you?
Not particularly
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
Measure the shaft diameter of your Pivot before you buy it. I made a mistake once and bought an M6.
ZETA's Clutch perch was an M8.
View detail
Since a disk rotor did not come to the center of the caliper bracket, it equipped. It is the left when the right will be approached if you have no spacer, and it is a washer of a home center. It was exact at a 0.5-mm spacer.
Since a disk rotor did not come to the center of the caliper bracket, it equipped.
It is the left when the right will be approached if you have no spacer, and it is a washer of a home center.
It was exact at a 0.5-mm spacer.
View detail