- Home
- Product reviews
- Search reviews
Reviews
Hexagonal hole accuracy not good enough, soft?
Hmm.
It is delicate to say the least. The hole itself is shallow because it is a low-head bolt, but if you tighten it with the specified torque, the tool will bite into it and the hole will be star-shaped.
I don't want to think about when to remove it. LOL.
Stainless looks good, but what is the cosmetic value in terms of total? Total?
View detail
No better than OEM Parts
I went back to OEM Parts within a few weeks of installing it.
Compared to the SCM435 bolt from OEM Parts, the strength of the bolt is absolutely insufficient. When I installed it, the tool mark was unusually deep when I tightened it with the specified torque, and I immediately thought it was no good.
The OEM Bolts were not inexpensive either, but performance should be more important than design in the installation of a critical security component Bolt. On reflection, I went back to OEM Parts.
View detail
Used for Disk bolt of MAJESTY 125
Even though others have already been written. Hexagon seems to be licking even if I use Torque wrench and tighten with Torque prescribed.
It is true also with pure Normal Thread Screw, but this hex of Bolt is not a deep hole, so it may be easy to lick.
Considering things at the time of removal, too much attention is given to Screw lock.
If you are worried you might as well buy Steel from OEM Product.
It looks like GOOD because it is hard for Rust to look.
View detail