Reviews
Good product, but expensive. (>_<)
Texture is very high (And the price!)
The height could have been a little higher, but it is acceptable.
When the footpeg is positioned at the back, even if the Change Pedal is set to the closest of the three levels, it is too far away for me, and sometimes it strikes out. (Bitter smile) I think it can be resolved by moving the footpeg position forward, though.
Also, the gizaGiza on the footpeg is sharp, so be careful when working with it. Even after installation, it is still slip resistant, but I am worried that it will tear when the Pants hit it when stopping etc... (Lol)
View detail
OEM for better or worse
I had it installed by Motorcycle shop when I took delivery of my car.
So, I have never held a standard Grip, but there is no sense of discomfort in the grip.
Since it is OEM Parts, I had a faint hope that maybe an Indicator would be displayed in the Meter panel. I had a faint hope that it might be displayed as an Indicator in the Meter panel, but it was just an indication of the Switch's LED operation. Too bad. (Bitter smile)
I used to use Endurance's 5-step, but well, 3-step is not a hindrance.
However, the strength (Warmth) The switch for the \"on\" setting is a long press and hold switch, so it is hard to tell which setting is on high, medium, or low, and the fine usability is not good.
We hope that the OEM's peace of mind will allow us to use the product for a long time.
View detail
Fits: SUZUKI DL800 V-STROM TECH, SUZUKI GSX-8R
Protection is better than appearance
You never know when something will come in handy, but it's expensive, heavy, and tacky.
Choice of appearance or protection
View detail
A little relief.
I had no choice but to attach the front wheel because I had to attach such a thing to protect it.
It is a reasonable creation with a low price, as it is a Parts whose price varies depending on the Design.
View detail
As long as you don't fall down….
Quality for the price.
strength (Effects) is hard to tell unless you roll over.
View detail
_TS.jpg)
Puch Rear Fender
Very good for preventing dirt around the rear area. It is easy to install and the clearance with the tires is exquisite. I think it is a good product for the price. View detail
It's worth a try!
The most difficult point is to attach the Screw to the back of the Rear Fender.
The color even pinches. [Color] Easy if you can Clear.
I couldn't do it alone….
Rear box is installed to TouringSpec!
View detail
Fits: SUZUKI GSX-8R
There were some parts in there that didn't work.
Purchased based on rationale for mounting on Mirror.
I tried to install it right away, but the Smallish color that comes with it is not usable.
I tried to fix the Camera by fitting a collar to the bracket to fill the gap, and then inserted the screws that were originally attached, but they would not fit.
I replaced it with the Screw that came with this Bracket and it does not fit.
I removed the collar and tried both Screws, but it won't go in.
No, you can't.
Since the color was not available, the original Camera Bracket was cut and the color was created. Finally, the fixing was completed.
I wonder if KIJIMA products are defective, I bought two products and both were not working properly.
View detail
Fits: SUZUKI GSX-8S, SUZUKI GSX-8R
Parts are missing if not purchased at the same time as the Side bag.
Support for attaching an OEM or SW-Motech made BLAZESide bag.
Purchased because of long touring plans.
The fit is good because of the quirky OEM.
The Male side of the anti-drop buckle is included with the Bag,
If you do not buy the bag as well, it will not be attached as per the Installation Instruction Manual.
Well, it's just a matter of putting a lifeline somewhere,
This is not a Large problem.
This Support + UniversalSide bag is also available.
The support part can be removed when not in use,
The Merit with the largest size is the one that does not interfere with Style.
There is something similar from GIVI, though,
If you include even the Bag, both will be a good price,
I guess it's a matter of preference.
The good thing about Soft bag is,
Is it a place where you can remove it and take it directly to your lodgings?
To be honest, as an equipment, it is backward compatible with Hard Case,
Waiting until the Hard case Fitting is available is also a Large ant.
Installation was a simple matter of tightening the Bolt,
Torque wrench is required.
Lastly, the passenger seat is over the passenger seat.
The tongue on the top of the Side bag is not cool,
GSX-8R can fit under Limit and Seat.
View detail
Fits: SUZUKI V-STROM800DE, SUZUKI GSX-8S, SUZUKI GSX-8R, SUZUKI V-STROM800
Basic decoration.
You won't know the effect until you roll.
If it cracks, I'll go cheap, and if it just shaves off, I'll buy it again.
Also, it might look tacky if you don't wear YOSHIMURA's Exhaust System.
View detail
Even in Fall down, Cowl was able to protect!
Bar End is scratched, Mirror is shaved, Knee Slider and Brake pedal are scratched, Brake lever is rather scratched! Brake lever is still usable! View detail
good-looking
Good looking! To install, TorqueOver attention to installing Bolt! View detail
Fits: SUZUKI GSX-8R, SUZUKI GSX-8S
Installation procedure is simple
A Long Size Hexagonal Wrench is required to remove the bolt at the mounting. It does not fit in the gap. Also, the screw lock is attached to the bolt, so it's a bit of a hassle. The rest is very easy. View detail
Fits: SUZUKI GSX-8S, SUZUKI GSX-8S, SUZUKI GSX-8R
Feeling of security
The bolt for installation tends to be over-tightened, so be careful when installing it or you will get stuck. View detail
It's easy, but Torque management is Large cut.
It is easy to install, but the tightness is not good if you are not used to it. View detail
Easy to install
It is easy to install, but the tightness is not good if you are not used to it. View detail
Either way, it gets dirty.
I wanted to keep the Fender from getting dirty, but the length was not long enough and it still got dirty, but I am satisfied with the fact that the dirt does not fly toward the suspension. The screw for installation is slightly different in pitch, so you have to be careful to install it properly or you will get stuck. I put a washer in front of the screw to avoid rattling and managed to install it. Is it the difference between millimeter and inch? View detail
Fits: SUZUKI GSX-8S, SUZUKI GSX-8R, SUZUKI DL1000 V-STROM800, SUZUKI DL1000 V-STROM800DE, SUZUKI DL1000 V-STROM1050, SUZUKI DL1000 V-STROM1050DE
Easy to use, but air bubbles don't disappear on their own.
Attached to GSX-8R
Quantity on the cheap:Since 1 Set of 2pcs,
In the meantime, if you want a Protection film.
You can't go wrong if you buy this one.
I had a few weaknesses,
Unlike recent Filmetc. for smartphones, the bubbles don't disappear.
Cheap Material:Plastic
Smaller in size relative to Meter
So, if you are an amateur who can't even apply water,
Attaching without air bubbles was impossible.
I don't mind if it costs a little more,
I wonder if it will be available in a spec. that eliminates air bubbles made of hard glass.
I sometimes wonder...
View detail
Fits: SUZUKI GSX-8S, SUZUKI GSX-8S, SUZUKI GSX-8R
This is good for the spirit.
If you are worried about dirt on Radiator when washing your car after a rain, if you can't tolerate crushed fins, or if you are worried about Small gravel splatter when driving near the shoulder of the road, there is no harm in putting it on. It is expensive, though. If you are not able to align the bolt holes with those of the RadiatorBody, loosen the bolt at the base of the bracket extending from the Engine and position the RadiatorBody. Both are 10mm. View detail
Fits: SUZUKI GSX-8S, SUZUKI GSX-8S, SUZUKI GSX-8R
Not so bad, not so bad.
The vehicle's helmet holder is attached to the tandem seat. Installation is easy. The texture feels cheap, but it is not a problem because it is not a part that cares about the appearance. Usability is normal. View detail