【JB POWER (BITO R&D)】FCR Carburetor Review
Fits: KAWASAKI ZRX1200S, KAWASAKI ZRX1200, KAWASAKI ZRX1200R
Vito car models Exclusive Design
I bought it because of Vito's Exclusive Design, but I thought it would be difficult to set it up, and I thought I would be able to drive it with the engine running, but I just popped it in and drove it. I could feel the power of Torque fully from the bottom to the top.
Nojima's Full Exhaust System & Silencer was a one-off silencer with a good exhaust system, but I was satisfied with the settings, which were better than I had imagined.
The funnel size is only 35mm, so it would have been better if a longer funnel was included as a spare.
I would like to take it to PowerCheck to check the air-fuel ratio and fine-tune it.
If you don't mind, I think you will be fully satisfied even with a pontoon.
Responses
Other reviews
Setting completed
Racing carburetor is still fun!
Run several times in the actual run setting.
Jet needle step change is almost ok.
View detail
It performed exactly as I expected. (*^^*)
Quantity, depending on the individual:Pair (for Left and Right) I think it will be done, but I was able to turn comfortably by adjusting only the Needle clip. View detail
The FCR Carburetor Body you've always wanted!
I had been on the fence about buying it, but I was informed that the price will go up by about 32,000 yen starting April 1.
I made the decision to purchase.
The setting for the car model was already out to some extent, but once the Jet and other products were installed, it was not possible to use them.
Checked the number of screw-related returns and tuned the throttle valve.
Also, I installed a SEPBearingGuide (I'll skip this since it has nothing to do with product impressions).
Installation is easy for those familiar with the OEMcarburetor, as it simply replaces the OEMcarburetor.
After starting the engine and adjusting the idling, the car was ready for a test run.
As expected, FCR Carburetor Body Response like a demon!
Acceleration like a demon...?
The Exhaust System has been replaced with an external one, so it is obviously thin. (Breathing at 6000 rpm)
Quantity of Main jet in the future:Set is purchased and Setting is issued.
Low speeds run without any problems.
After all, it is shipped with the settings for the car model, so it will run to some extent.
From there, I'll boil it down to my own taste.
View detail
FCR Carburetor Body of your dreams
My first impression of the installation was that the Throttle was very heavy! No amount of Wire routing or type of Wire could improve it.
So we changed the Spring to a lighter one, and it now feels as good as the OEM one. The spring change is not possible without a full reverse operation.
Other than that, the acceleration power is as good as its reputation.
View detail
Good quality
The installation itself is very easy. However, it takes a little getting used to the settings. However, the manual comes with the product, so you don't have to worry. View detail