【KITACO】Full Exhaust System Gasket (1 Set Of 2pcs.) Review
Fits: HONDA DJ-1-RR, HONDA G', HONDA CABINA 50, HONDA CROSS CUB 50, HONDA JULIO, HONDA JOKER Helmet 50, HONDA Giorno, HONDA SUPER CUB 50, HONDA SUPER CUB 50, HONDA SUPER CUB 50 Standard, HONDA SUPER CUB 50 DELUXE, HONDA SUPER CUB 50 Super custom, HONDA SUPER CUB 50 PRO, HONDA SUPER CUB 50 PRO, HONDA SUPER DIO, HONDA SUPER DIO -SR, HONDA SUPER DIO -ZX, HONDA TACT, HONDA TACTSTAND-UP, HONDA TACT,
Small Additional Price to Pay When Installing a New Exhaust on the Monkey 125
About quality and texture: I am happy with the quality of the exhaust system gasket from Kitaco. A compressing gasket with an external diameter of 32mm and an internal diameter of 26mm. About the feeling of use: The exhaust system gasket is a firm fit and holds itself in place once positioned and has sealed the interface between the exhaust port and the exhaust pipe with zero air leaks. Products to buy together: Some replacement exhaust stud nuts would also be desirable to purchase along side exhaust system gasket as mine were cosmetically damaged from using an open end spanner due to the thickness of the exhaust pipe and not being able to use a socket. Difficulty of installation: The process to install took about 30 minutes, loosen the exhaust stud nuts so you can lower the exhaust pipe to access the exhaust port to replace the exhaust system gasket. The old exhaust system gasket was very tight and difficult to remove on this motorcycle and required the use of a small flat screwdriver to lever it up from the bottom edge and I would recommend using something softer as the screwdriver slightly maked up the exhaust port surface. Refit the exhaust stud nuts and tighten to 27N.m. Cost performance and comparison with other products: Good costing as you are getting two quality gaskets from Kitaco that are always in stock and ready to ship but the genuine Honda gasket is slightly cheaper but you have to wait a while for stock to be available. About shipping and packaging: Sea freight was my preferred method of shipping due to the lower cost but currently this service is unavailable from Japan Post, EMS is much faster which is nice. Webike kept me updated on the status of my order up to when it shipped. The parcel arrived within the expected date range and was well packaged with no chance of the part being damaged. Any concerns, cautions, or advice when purchasing: Kitaco or K-Pit offer many replacement gaskets for the Monkey 125 that can be viewed in the Kitaco engine tuning and maintenance parts catalog and stock is available and ready to ship here on Webike.
Responses
Other reviews
Gamma's OEMChamber requires 4
[How is it used?
RGV250Γ (VJ22A) The new one was replaced with a new one for the ChamberMaintenance of the
How was your experience with it?
This was the first time for Gamma to install and remove chambers, but the description said that 4 chambers were required, so I purchased 4 chambers as described.
One SideQuantity on the Flange side and the Engine cylinder side between the chambers:2pc. I used 4 of them for sure because I need Set.
I installed it with a light Gasket and so far it is working fine with no exhaust leaks.
How did it compare to other products?
It was not particularly good or bad.
[Points to note]
At first, it is difficult to install because the direction of installation is upside down!
It is better to stick with liquid Gasket and replace it. (Large strange to take it later, though).
【Review】
It was cheaper than OEM and functionality was fine.
For OEMChamber, 4 pieces are required, but for external chambers, it is usually Quantity:2pc. Set, or maybe even none.
View detail
KITACO Exhaust Gasket
Exhaust Gasket for ADDRESS V100
ADDRESS V100 that needs to remove the chamber not only when replacing the chamber but also when replacing the rear tire.
Buy Exhaust Gasket Stock because I want to keep it.
I have used KITACO products in other vehicles and think they are reliable.
View detail
SR400Exhaust pipe replacement
The texture feels cheap compared to OEM Product, but there are no exhaust leaks.
I thought, "Can't I reuse the exhaust pipe and silencer at least once? However, it is very troublesome to re-install the exhaust pipe and silencer after the exhaust leak is discovered, so we will not be stingy and replace them with new ones every time.
View detail
In reserve for Replacement
I bought this as a spare. I will probably purchase more soon! View detail
I was prepared, but ….
The Gasket could not be removed and was reused, although it was inexpensive and ready to go. View detail