【DAYTONA】Golden Pad x Brake Pad Review
Fits: SUZUKI GSR750, SUZUKI DL650 V-STROM XT, KAWASAKI ER-4n, SUZUKI SFV650, SUZUKI SFV650, SUZUKI SV650 S, SUZUKI SV650 S, SUZUKI SV650, SUZUKI SV650, SUZUKI V-STROM1000, SUZUKI GRASS TRACKER BIG BOY, SUZUKI GRASS TRACKER, SUZUKI GLADIUS650400ABS, SUZUKI BANDIT250 V, SUZUKI BANDIT250, SUZUKI BANDIT250VZ, SUZUKI Volty typeT, SUZUKI Volty typeI, SUZUKI SV400, SUZUKI GSX750F,
Definitely Brake Pads!
With the OEM pad, I could only hear a scraping sound when I applied brake, and I had to hold the brake quite a bit to get the desired braking effect. The braking effect is different from the initial braking. Of course, it is easy to get the ABS to work if the brakes are applied strongly on asphalt road surfaces.
The price is not that high, and considering the safety, Fee Ring and durability, the cosmetics are definitely a good choice.
After replacement, the "A safe place." In other words, after three cycles of hardening, the pad is blended and the BrakeTouch becomes even silkier. Try it.
Responses
Other reviews
Reliable Braking Power
[How is it used?
It is installed on a NMAX 155.
I bought a used car and replaced it with a Timing with a total mileage of over 10,000 km.
Since this is my first Pad replacement, I have not been able to compare it with other Other Brand Products.
How was your experience with it?
The Pad at the time of purchase of the vehicle is probably from Standard Equipment, but it is a more stable braking force than that.
It is very important to be able to stop safely as it is a commuter vehicle that we ride every day.
However, there is no sense that it is dangerous to stop too much, but only that it is safe to stop strongly, which is very good for Fee Rings.
The other part is how much Life is, but that will be discussed later, as it hasn't been that long since the replacement.
View detail
METAL but not Snap.
I always thought it was Casting Iron because SV650 has a magnet on the Left Front Brake disc rotor, but when I looked up the magnet on the CB1000R, a high-end motorcycle I recently bought, I found that there is a magnetic stainless steel version, which I think is the one used in commercial motorcycle rotors. I think the motorcycle rotors are made of it. It is said that about 70% of general stainless steel is SUS304, and the 300 series is the most rust-resistant stainless steel without magnetism. I could not see much change in the pad. But it should have a good life span. View detail
Stainless rotor
The OEM Brake Pads I have used so far were replaced after 25000km and DAYTONA Red Pad after 10,000km. The exception is for Race. The exception is for Race. View detail
It is very good as a substitute for genuine product.
I bought them because I wanted slightly better brake pads as a replacement for the original ones. As a result, it did not have better braking ability than the original. However, if you use it as a replacement for the original product at a low price, it will be an appropriate alternative and not inferior to the original product.About quality and texture About the feeling of use Products to buy together Difficulty of installation Cost performance and comparison with other products About shipping and packaging Any concerns, cautions, or advice when purchasingAbout quality and texture About the feeling of use Products to buy together Difficulty of installation Cost performance and comparison with other products About shipping and packaging Any concerns, cautions, or advice when purchasing View detail
Beware of over-effectiveness
Repeater
Pad was also replaced along with the replacement of the Rotor.
I am amazed at how well it works between new products.
The difference from when we only changed the Pad is huge.
Chombre works well enough.
View detail