【SP Takegawa: SP Takegawa】ไฟท้าย LED Review

Looks pretty good!

It is said to be a common product with KSR110, but in fact it is slightly different.
The Ninja 250R is installed on a Ninja 250R, but the Ninja is DC powered and the KSR110 is AC powered, so the Instruction Manual is a must for installation on a KSR.
Some Wiring processing is required and Earth needs to be pulled. View detail

Attached to Ninja 250R

I installed it for Dress-up purpose.

I chose smoke because I was lost with Smoke or Clear, but considering the balance with Blinker, I think Clear was good.

There is also a polite Instruction Manual for installation, it is unnecessary and unnecessary to process Wiring etc. It is very easy.
I think that the price is somewhat high, but since it is obviously different from the OEM Product, such as the feeling of lighting, I think that these kinds of things are alike in order to differentiate.

However, it is the only disappointing point that the BALI at the time of cutting out parts remained in the Lens cover. Besides, it is a very conspicuous part at the top of the Lens cover, so I think that we would like to improve this place by all means. View detail

It turned out by other persons' NINJA that an Image changes to the extent that it took in upper another vehicle type, when the Tail lamp was changed to LED Types, such as a Clear and a Smoke. being put on the market from the Manufacturer of , however

It turned out by other persons' NINJA that an Image changes to the extent that it took in upper another vehicle type, when the Tail lamp was changed to LED Types, such as a Clear and a Smoke. being put on the market from the Manufacturer of
, however a large number -- -- it was alike and there was no product called コレッ easily by non-なり .
When many things were searched and the photograph of the product of this SP Takegawa was seen, it was felt as コレッ, and an order was placed. Although the price is cheaper than other Manufacturers, structure with highest-class texture and perfection are this thing. Formally, although an order sheet, a Side cover, a Seat cover, and a Center Seat cover are removed and a Tail lamp is desorbed,
attachment, If the Bolt which removed the Tandem seat actually and has stopped the Center Seat cover is removed, and a Center Seat cover is removed, extending a Seat cover so that it may be forcibly wrenched open, it is possible to remove a Tail lamp. Since there is incidentally no explanation of a fine mounting arrangement in a product, those diffident need to refer to a Service manual. Tools required for
exchange are a 4 mm hezagonal wrench and a 10-mm Socket wrench. Probably, it will be better in the back, for a pure Tail lamp to prepare two Velcro tapes of an about 2x3-cm adhesion type, since it is being fixed by the Center Seat cover and the Velcro tape (Magic tape). There are five parts transplanted from a pure Tail lamp in others. Since it is a narrow place, although work is serious, it does not have a difficult thing. Brightness when expectation of it is exceeded far and the light is switched on, and the high grade feeling of the high grade feeling after
exchange finishes are also exceptional. A NINJA with a poor-looking circumference of rear one is also visible to completely another upper vehicle type. View detail