【KITACO】Super Oil Pump Kit Review
Fits: HONDA monkey, HONDA monkey, HONDA CRF50F, HONDA solo, HONDA Super Cub 50, HONDA Super Cub 50, HONDA Super Cub 50, HONDA Super Cub 50, HONDA XR70R, HONDA XR50R (for competition), HONDA CRF70F, HONDA MAGNA50, HONDA CL50, HONDA GORILLA, HONDA GORILLA, HONDA JAZZ, HONDA GIORCUB, HONDA DAX, HONDA CUB press 50, HONDA CUB press 50,
It is not installed yet
Gasket is included as well, just replace it.
I also thought about wearing at the same time as Bore up, but I thought I was going to wear it with another Timing.
I tried turning by hand, but I go to Smooth.
Precision looks good as well.
I expect that it will be effective when installed.
Responses
Other reviews
If you want to put on Oil cooler!
Installed to attach oil cooler!
Cheap and cosy?
View detail
Used in MONKEY
I don't know how effective it is, but I made it 88? and I bought it for peace of mind.
It is also safe to say that KITACOBrand.
View detail
InsuranceParts
Incorporated with Bore up.
There are many theories as to whether it is really necessary, but it is better for your mental health to have it set up as an insurance policy.
However, if the orifice diameter expansion Large is not done in conjunction with the orifice diameter expansion Large, it will not make much sense, so processing is a prerequisite.
Also, it is highly likely that the Plus screw for fixing is damaged when removing the NORMALPump, and since the fixing screw is not included, it is better to prepare a suitable size or a spare OEM Product.
By the way, I have been shibaing down Mt.
View detail
Orifice extension required
Bore up, Clutch We replaced the Oil pump after the exchange.
Replace itself by removing + Screw 3, replace Gasket, just align the cutouts of the shaft.
Orifice 1. PinDrill is useful for extending to 5 mm.
If you do not leave Stud bolt you will not get ordinary Drill.
Case is Aluminum, so I was able to scrape crisply with a thumbwheel.
View detail
It exchanged from the NORMAL Pump simultaneously with formation of an 85-cc Bore up, and strengthening Clutch introduction. Since the futility of the three 2 times time-and-effort time and effort of work [ a direction ] or an Oil introduced simultaneousl
It exchanged from the NORMAL Pump simultaneously with formation of an 85-cc Bore up, and strengthening Clutch introduction.
Since the futility of the three 2 times time-and-effort time and effort of work [ a direction ] or an Oil introduced simultaneously with them since it is necessary to remove the
Clutch or to remove a Cylinder for Orifice processing was excluded, I thought that it was good.
Since
Orifice processing only expands a little existing hole, it attaches a Drill to a Pin vise and can expand it easily only by making it rotate by hand.
Therefore, it is not necessary to remove a Stud bolt.
It expanded to 1.4 mm this time.
If generation of heat by a Bore up is considered as the
Manufacturer also recommends, I will think whether it is safer to carry out strengthening of an Oil pump.
View detail