【KITACO】Exhaust System Joint Gasket (1 Set Of 1pc.) Review
Fits: HONDA PS250, HONDA APE 100, HONDA APE 100 TypeD, HONDA FORESIGHT, HONDA FORZA Si, HONDA FORZA Z, HONDA FORZA(MF06), HONDA FORZA(MF06), HONDA FORZA(MF06), HONDA FORZA(MF06), HONDA FORZA(MF06), HONDA FORZA(MF08), HONDA Forza300
As a Gasket when using outside Aluminum silencer
【What made you decide the purchase?】 There are various Size
【How was it actually used?】 There is no problem with airtightness
【Was it difficult to install? (Hard parts case)】 Easy
【Please tell me the point of installation and hang (in the case of Hard parts)】 Subtle size adjustment is done with Gold saw
【Fit feeling and height when wearing - Please tell me the weight etc (Apparel case) 】Any
[Is there anything I was disappointed about?] Easy to adjust
【Hope for Manufacturer - Please tell me if there are any improvement points】 No particular
【Have you compared items?】 OEM Product
[Others] OEM Packing can not be used in many cases such as the Exhaust System of the Other Company Product, and it is used for size adjustment. Material wrapped iron fiber with Aluminum. If Packing's inner diameter is Small, you can adjust the Size by inserting a notch vertically with a Gold saw. I think that the error of 1? Is within the range of adjustment. There is also no exhaust leakage.
Responses
Other reviews
It's not very plain, but I always replace it.
Purchased this one because it is slightly cheaper than OEM. I don't think there is much of a problem. I know many people reuse them because they tighten so tightly, but considering the significance of Gasket being used there, I think they need to be airtight. So I'm not being stingy and replacing it. I want to change the OEM with an external Exhaust System, which for some reason comes” regularly! I change them when I'm in the mood to”change them. View detail
If only it were a little cheaper…
I am purchasing this because I need it to replace the Slip-on Silencer.
The quality is fine and it prevents exhaust leaks well, but it is a consumable item and I would like it to be a little less expensive.
View detail
Used for WR155
[How is it used?
I used it to replace the YOSHIMURAExhaust System on my WR155.
How was your experience with it?
It is usable without leaks of exhaust Gas.
How did it compare to other products?
I have never used KITACO and OEM, but KITACO quality is close to OEM quality.
[Points to note]
If not tightened firmly, it will leak.
Other items that would be helpful
Whether there are Included Parts:/ Items that should be purchased together/Opinions and requests to the Manufacturer
nothing special
View detail
OEM Parts same as above.
Used to replace the Exhaust System on a 2001 D Tracker with an external Slip-on Silencer.
OEM Parts No. 11061-1055
For late D Tracker and KLX.
The size of the Gasket is different from the previous year's Gasket, so you should check carefully when placing an order.
I was able to install it on Beauty by installing it on the Slip-on Silencer side and then inserting it into the exhaust pipe.
View detail
Tightly made
At first I thought it was defective because it was too tight, but when I pushed it in slowly and carefully, paying attention to the angle of the frame, it went in like a hammer. It may be a bit expensive, but every time I replace the Slip-on Silencer, I replace this one as well. View detail