【MRA】Screen Original Review

Easy to use as OEM compatible without distortion

Used on ZZr1100 (C1).

The OEM screen was damaged from the attachment point due to age-related deterioration, so MRA's screen was introduced this time for the purpose of repairing it. [Color] Clear? [Color] I was wondering if it was Smoke or not, but this time I decided to use it as a makeover. [Color] Smoke.

The OEMScreen is slightly thinner than the OEMScreen, but has less distortion than the OEMScreen, and has good visibility even when it is tucked into the cowl.
However, Smoke Screen is darker in color than I had imagined, and I think it would be tough to run face down with Smoke Shield's Helmet late at night.

A Screen RimRubber was also included and its length was appropriate and favorable.
I am glad to see that they are making parts that fit older motorcycles as well, as screens wear out due to scratches from flying rocks and need to be replaced periodically. Next time I will try Clear Screen. View detail

It may be a little tricky to install if it is your first time.

I replaced it for the first time because the Screen had cracked over time. Naturally, the OEM product was not available, so I was very happy with the product. The product itself is very good, the large size is about the same as the OEM Product and the holes fit perfectly. In the product description [Color] The screen I received was clear/graded, but there was no gradation on the screen. I was fine without the gradation, but now the screen is very transparent and I can see the back of the meter without the OEM gradation. The price is not too expensive and I am very satisfied. The installation depends on the type of car, but I think it will be a surprisingly difficult job if it's your first time. It is not difficult or complicated, but I had a hard time removing the well nut from the screen and upper cowl before the replacement. It is better to remove the upper cowl, although it is troublesome, and you should ask for a new well nut when you install the screen. The old well nut is not reusable. I had to go to the store to buy it because I didn't have the old one ready. It didn't fit easily. The new screen has a clear protective seal on it, so it is better to peel it off before you start work. I noticed the protective seal after I finished and had to start all over again. View detail

Excellent replacement screen

Since the oem screens are no longer available this was my next choice. Excellent fit, mounting holes lined up perfectly. The only issue is the trim piece they supply is horrible. Clear trim that you are supposed to secure onto the screen with metal clips. I bought black rubber trim on Amazon and cut it to length. View detail

OEMScreen was damaged.

I installed this on my 2012 CBR1000RR.
Small scratches on the OEMScreen were becoming noticeable and were replaced.
I think the shape is almost the same as OEM. [Color] Compared to the Smoke-sensitive OEM, this product [Color] The clear design allows for better visibility and recommendation. The installation is also an insertion type, which makes it easier to replace than OEM. View detail

FZ400R (46X)

Size and shape were perfectly fine.
The mounting screw holes are precisely positioned and the OEMScreen is removed and left in place.
Installation was easy.
The lower Screw hole is in the Upper Cowl, so it may be a bit of a hassle to remove the Cowl.
The process is simple. View detail