【MORIWAKI】Nn Shaft Review

Beware of SAPivot bearing specs. which are thicker than OEM shafts

In conclusion, the Pivot shafts (made by OVER) in the external Swing Arm
and the rear axle shaft did not work
I don't know if it's an individual difference, but the NNShaftQuantity I received on my end:I measured 2pc with a handheld Caliper
There was 12mm at ShaftCenter
The MORIWAKIEngineerRing that was inspected during the return process had the same opinion

The OEM Axle and Pivot shafts are the same
[OEM Product No. 42301-K26-900]
The inner diameter of the new OEM RearAxleBearing is 12mm JUST
I had to beat it because Clearance is zero or strong
The Bearing was damaged during several insertions and removals

It's not a rotating shaft under normal use, so I don't think it's going to wear out
The OEMAxle Shaft diameter at 4000km was 11, 90-92mm
KOOD (made by Kowa) is nearly 12mm long, but it is thinner than MORIWAKI's
Like the OEM Shaft, they can be attached and detached by hand only
We talked directly to a person from MORIWAKI product development department during the process of Objection support the..
NNShaft is only available on OEM pivot shafts (12mm and larger in diameter)
It seems to have been designed to be used for
We can remove the footpegs from any side is the Concept
The pivot bearing part of Axle Shaft and Other Brand Product It is not expected and not applicable to use for 12mmJUST (both 12mmJUST) by the Manufacturer ]
I just wanted to ask Ue-Big to include this one sentence in a postscript
Except for granting a 10% return guarantee point
I am very disappointed that you have not taken any action externally
Part of me is to blame for putting it on without any doubt that it would go in
It's just a bad aftertaste for breaking a motorcycle somewhere to improve
I'm posting this for the benefit of other Users so that they don't have to go through the same thing I did
Please be careful

We had several names, one after the other
We-Big Customer Service
Let's just do our jobs a little better View detail

It goes in easily

I installed it in conjunction with the Swing Arm replacement
Both SidesLock nut I was worried about whether or not it would be used together, but I was able to install it without any difficulty The footpeg replacement becomes considerably easy
The downside is that it's Uniqlo's Material, like the OEM, and it will rust at a later date I think it's a bit expensive for Uniqlo (Accuracy is pretty good.) View detail