【ZETA】Revolver Shift Lever Review
Fits: YAMAHA XG250 TRICKER, YAMAHA XT250X, YAMAHA SEROW250
Expect durability
[How is it used?
I replaced the OEM Shift lever with this product because it was easily bent.
Was the one you received as per Image?
I liked the texture better than Image.
Was the installation difficult?
Just remove the OEM shift lever and replace it. There is a groove on the shaft of the Pivot that holds the grease, so you can apply a generous amount of grease and wipe off any grease that sticks out.
How was your experience with it?
The Tip now comes in much higher than OEM, which I think is just fine considering what happens when you wear Boots.
[Included Parts:were they on?
Not particularly
[Was there anything that disappointed you?
Not particularly
Other items that would be helpful
It is a tip of the tip, but it is fixed temporarily. Please be sure to fix it by applying Screw lock. If you don't apply it, it will be dropped immediately.
Responses
Other reviews
Shift Pedal
GizaGiza synthesis on the part where the clutch is attached looks like a bad lick! View detail
be extremely thorough, focusing on even the finest of details
I guess it depends on off-road boots and the size of the foot, but I replaced it with NORMAL because it was hard to operate in Standing.
After adjusting it several times while riding, I was able to operate it Smoothly and was satisfied with Large.
View detail
Improvement of appearance
Parenthesis looks great - the shift position can be fine-tuned by rotating the tip... It is easy to install. View detail
Merit is Large size with your choice of Position.
I was not dissatisfied with the OEM, but I bought it because of the 4-position option.
Touch is also very good, and I think this Merit is Large because it is an important part for a 2-stroke vehicle like YZ125 that needs to be changed frequently.
The Bolt position is also better than the OEM position, which clamps from the bottom and is less likely to fall out.
View detail
In the targeted Position,,
The pedal position of the OEM YZ125X is a little low, but if the serration is moved up one notch, it is too high.
The result, as you can see in the picture, is the same as the OEM, or even lower, even with the tip adjustment turned up.
Then I tried to lower the tip adjustment while shifting the mounting position by one, but it was a little too high.
I tried it on a run, but I felt it was a little too high and difficult for me, although I guess it depends on whether you prefer to lift the SHIFT UP only by the ankle or by the whole foot.
A small difference can affect the operation quite a bit.
In the end, the position of the Serration was almost always determined by the position of the tip, and the tip adjustment could not be positioned to aim in the middle of the Serration.
The photo shows a ruler placed on the footpeg, I hope you can use it as a reference for the height.
If the height is right, it would look good and be good, I think.
Incidentally, the bolt at the tip was replaced with a good one just to be safe, and Screw lock was applied before installation.
View detail